I need to replace these. Last time I checked (last year?), Duckworks didn’t carry them. (They’re 36 x 2 x about 1/2.) I could get them done custom here, but I’d need to find the stock material. Or I c

And blew it around the yard a bit. The bow pulpit rails are mangled, and I doubt that they can be straightened. I guess I need a new one or a used one. The mast was also bent and blown off. The riggin

Need a new mast and all new rigging, where should I buy? Thank you Giorgio

Selling my Potter located in Springfield Illinois. Very clean straight boat stored indoors in my basement! All woodwork refinished to as new condition. Lots of extras including chart plotter. Very nic

I replenished the lower unit gear oil yesterday. I position the motor in the tilted position, turned to the side and poured oil into the top (fill-line) screw. When it topped off, I replaced the plug

I have a #1985 #WWP19 for sale. In 2020, although it was in good shape, it received a restoration. Other than a couple minor items yet to be completed, it was a complete restoration including a new Ma

Has there been a problem with the OEM cotter pin shearing? fatique or corrosion issues do exist quick math here: Is that pin 3/32 or 1/8" ?? 316 Stainless has about 89,000psi tensile strength, shear s

Hello all. I'm hoping someone can tell me what is the current factory keeper for the vertical pin that holds the downhaul thimble under the U joint? I got mine with my hull #622 1975 P-14 "Mk I" and i

Hi All, to prevent "drowning" the trailer lights & wiring at every outing, whenever I get a "new" sailboat, I make a rudder pintle Mast crutch "cross" for it. If the boat came with a crutch, then I at

Hi everybody, I am looking for the (hopefully) factory made, pintle-mounted mast crutch, if anyone would sell one to me. Thanks!

Small Craft Advisor Magazine is conducting a poll/match up regarding the best small mini-cruiser. The West Wight Potter 15' made it into the second round but is now facing a formidable opponent in the

I have a pipe with an internal thread 1.426 inches or 36.2204mm diameter threads 114 per inch or 2.8956mm I want to connect it to a standard American pipe 1.25 inches in diameter with coarse thread. I

Meticulously setup and maintained bluewater layup/premium package, outboard, sails and trailer. New color coded running rigging, set up for short handed sailing, upgraded electrical system, new barrie

At ~60 lbs a 4hp 4 stroke long shaft is definitely too heavy for the WWP 15. Add a 3 gallon tank and my own svelte figure wrangling the two at the stern and it's just not pretty at all. The extra weig

“Blue Potter” is a 2002 WWP15 in suberb condition. She has the blue water layup, brand new custom sails, all new rigging, working running lights with new electric panel, sail cover, jib bag, spinnaker

Before selling "Titmouse", my Potter 15 Mk1 this past week to a nice gentleman up in Nebraska, my children and I decided to make some memories, stretching her wings a bit on Father's Day. I got the bo

I am currently over-boated (3), so I am regretfully putting Par le vent up for sale. The boat is a 2001 WWP-19, with a trailer and outboard, hull number 1268. I have had her for 3 seasons, but last ye

Paperwork from State DMV took months to return complete, hence my relisting again.

Where is the best place to mount a solar panel on a P19?

Hello Potter Trotters, I am giving any member in the group, advance chance of acquiring my yellow, mighty lite trailer sailer. Bound for a new steward for 3000. (Sailboats are like cats, we don't own