I just noticed that JKS has made the forum available again, though read only for now. http://forum.kiwisdr.com/index.php?p=/categories/kiwisdr-discussion

Thank you Rob Completed on my end, no issues. Tom

Your WD directories were not created with git Save your conf files snd do a clean installation using git -- Rob Robinett AI6VN rob@... mobile: +1 650 218 8896

Worked fine here On 8/9/21 4:13 PM, Glenn Elmore wrote:

On two systems. Was this because I downloaded via wpsrdaemon site? Where/when does the repository get set On 8/9/21 12:35 PM, Rob Robinett wrote:

Thank you Rob, Just did it, went fine. Steve

This version adds WD's SW version number to the spots it uploads to wsprnet.org. That site doesn't display those version numbers, but wspr.rocks will print that version number field. Also, version

Thanks to an observation by Clint KA7OEI, I found and fixed a problem in the WD server which caused noise graph files to not be displayed. The WD server wakes up every 5 seconds, gets a list of .png

Has anyone looked at DigiSkimmer? https://github.com/lazywalker/DigiSkimmer Seems to be using a similar approach to Wsprdaemon to deliver the basic WSPR spotting functionality (none of the clever

As I understand it there is at least one RF problem because they have two RF inputs, one with a 30 MHz LPF and a second with a 60 Mhz LPF and the filter outputs are both always connected together at

On the Kiwi I have been measuring the voltage on the USB-A port of the BBG and then adjusting the PSU to get 5V on that unloaded USB-A port. I have found that the the resulting PSU output is typically

Rob Just curious about the "serious Rf problem" on the FD cape. I took a peek on the website and most certainly it looks to me that their enclosure is not optimal when it comes to cooling the raspi

That looks pretty straight forward and yeah I already edited my local copy of your example .config file so I wouldn't forget to set localhost:8073. Well I guess now it's just hurry up and wait

Just log on to the Flydog's Pi as user 'flydog' password 'flydog-sdr' execute 'sudo apt-get install git' then follow the installation instructions on my github page. there are many, many packages

The WebSDR system seems to best address the latency issue of the Kiwi and many other SDRs and thus more popular with ham operators. You can compare the KFS WebSDR at

I think it wasn't a Kiwi at the time, just two collocated antennas with the receiver running continuously. The rx may have been an analog radio or an Apache/Anan dual-ADC board, I can't

I suspected that but wasn't sure. I don't expect to see my FD arrive till September probably but in the mean time if you have any chance to write down the steps you used it will help me a lot and

It was a typo. I was working on the FlyDog -- Rob Robinett AI6VN rob@... mobile: +1 650 218 8896

Is that a typo for Flydog, or sarcasm, or is there actually another SDR called Firedog? I looked but came up empty?

On Sat, Jul 24, 2021 at 11:14 AM, Glenn Elmore wrote: It was rather fun to be 'full QSK' on SSB or CW.Glenn, how did you deal with the processing delay? Here it is almost a full second through the