Date
1 - 5 of 5
Launching configuration Wizard
|
Cliff
Den,
toggle quoted messageShow quoted text
With the Config Tree then click on the arrow at the end of each heading to open the submenu items.
73,
Cliff, AE5ZA
|
|
|
|
Michael Coslo <mjcn3li@...>
Taking a wild shot at this, but when I open the configuration menu, It has to be on the same screen as the main program. Sounds strange, and took me awhile to figure out.
toggle quoted messageShow quoted text
- 73 - - Michael Coslo - Frequency Coordinator, Beaver Stadium 814-404-3991 mjc5@... mjcn3li@...
On Aug 24, 2020, at 7:40 PM, Dennis Niles <kh6xt@...> wrote:
|
|
|
|
Dennis Niles
Hi, Nate Appreciate the reply but once I go through the config wizard, I can't later change any setting; for example, change an audio port. I just get the "tree" on the left side of the page but am unable to open anything.. In sum, I can't scratch the surface let alone drill down. Hope you can help. 73, Den WV7S
|
|
|
|
Rosenthal Nathan H.
On the top menu there is the word "Configure". Click that to bring up the configuration menu. Then drill down to what you need.
Nate N2ADD
|
|
|
|
Dennis Niles
I need to fix com port settings but can't figure out how to get to the configuration wizard. I am running ver4.1.14/RigCAT - FT991. CAT is working fine - - mostly. Frequency read out, mode etc. all ok. I'm able to send CW using a WinkeyerUSB. So far so good. But something changed so that Fldigi no longer de-codes CW andI don't get a popup showing CW speed as I rotate the CW pot on the keyer. Without access to the config wizard, I'm stuck. Any guidance would be appreciated. 73 Den
|
|
|