When I listen to CW that is "well-timed" (like W1AW CW bulletins) the FLDIGI, in CW op mode, copies 100% on 3581.5 kHz in the evenings. What more is needed? Poorly sent CW is easy on my ears, but no

Fldigi’s integrated CW decoder works really well. Is another one needed?

I have been thinking of taking on the challenge of writing a CW decoder having been in the signal processing world for a long time. If this works well, is there interest in this group of integrating

Winlink is supported at https://groups.io/g/Winlink John / KS6M

+ AA6YQ comments below In the DXLabs API there are recommended ports for the DXLabs Apps to use. 52001 = DXKeeper, 52002 = Commander and so on. These should be the default port numbers in the

You could use hamlib's rigctl.exe to do something with that info. Redirect it to a file or use it in a script to set ENV variables or such. rigctl -m 4 f m 3573000 USB 4000 Mike W9MDB

Messages send via packet winlink are showing up in my personal email and not showing up in inbox of winlink express can not find a setting to fix it. -- Scott Morse -KC6SKM

Would like to know if the radio's current frequency and mode values are available via FLDIGI to export into Windows? To be used as variables on a custom local web page. Thanks and 73 Robert W5IUA

I've had this same problem since 4.1.15, although the error happens on line 1061 in the code. I've just been hitting the Ignore button and pressing on. The software seems to work fine

In the DXLabs API there are recommended ports for the DXLabs Apps to use. 52001 = DXKeeper, 52002 = Commander and so on. These should be the default port numbers in the gateway. If they are different

Not sure if this applies, but just had the same thing happen. Checked the default port in DXKeeper and it was set to 53000. Checked the port setting in the Gateway, and it was set to 52000. Changed

Definitely OK release loads and runs much faster than vers15 did Sound card config uses port audio and JackAudio system selection for both ports On 2020-12-04 2:02 p.m., Andy_VE4PER

Solution 4 Me to get successful install (linux OS is ubuntustudio 20.04LTS with Jack Audio Connection Kit installed rig is IC-7300 using USB port) root@Hostname: cd

Hello Brian, I tested PSK31 both ways from Fldigi to AndFlmsg and reverse, with and without RSID. I tried two Samsung and one Oppo phone and they all worked here. The only thing I can think of is a

Dave et al; I have not experienced any issues with MS updates changing or replacing drivers. Now, I do allow automatic updates to Windows 10 Pro 64 bit. What I strongly

after completing tar of the file it runs ./configure completely but make gets a  "make: *** No targets specified and no makefile found.  Stop."  so the subsequent make install does not work. any

I am trying to compile flxmlrpc to get flxmlrpc.lib using mingw32 in a Cygwin window on my W10 laptop. What switches should I apply to ./configure? I tried the same switches as I think I used to get

I have tried this on two different computers with the same result this morning. Not sure which software is causing it to not work. FLDIGI 4.1.17 will connect to most of the other Contest software from

Very good, thank you! -Brian WB8AM

Murf.. I replied to your message in the DXLabs group. Follow it and send me the debug file so I can see what is going on.. 73 Rick N2AMG