Date
1 - 3 of 3
Genesis GP40-2
|
Hello everyone, well Athearn won't stand behind the fact they installed the wrong resistors on my motherboard so I've got to order a new one. After looking at their site I see a couple to choose from but I can't tell which one I need. Any help would be appreciated.
Sam R. Lewiston Maine
|
|
|
|
I would use a Decoder Buddy. The resistors will be right and it's less expensive. Craig Zeni Cary, NC Despatched from my infernal Android
On Sun, Jun 13, 2021, 03:21 Sam Robinson <samuelrobinson388@...> wrote: Hello everyone, well Athearn won't stand behind the fact they installed the wrong resistors on my motherboard so I've got to order a new one. After looking at their site I see a couple to choose from but I can't tell which one I need. Any help would be appreciated.
|
|
|
|
Thanks for the advice. I went ahead and ordered 2 of them because one of my other locomotives with LED's needs one. One of them has both front and rear flashing ditchlights. I can't figure out where to solder the wires onto. I was also told that in order to make them flash I need to solder the wires onto specific pads? I figured the 21 pin Tsunami2 sound decoder would handle that like it does already?
|
|
|