When I connected my Harbor Freight meters to the output of the Power Cab Had a loco on the track running. They all showed close to 13.6 vac. My Tek scope verified. I did the math conversion. I

I have had my DCC set up for a couple of years. For the past year I I have been unable to do anything with it because of a health problem. I have the engines set up but can not remember how to put the

LLoyd, Who's DCC system do you have? Allan

I have Digitrax

Lloyd, Do you have a Zephyr or a Chief? (I assume since you had your system for a while, you don’t have an Evolution.) You said you don’t know how to set up a locomotive on your system.

On larger layout without a load, you will see the track voltage go up the further you get away from the DCC system or booster powering the track. The is voltage ringing (spike) on the DCC waveform

Can anyone tell me if you can control HO DCC using MTH PCS ?

The MTH DCS system cannot control DCC locomotives. Some MTH locomotives can be controlled either by MTH's DCS or DCC systems. All the MTH locomotives I own are like that. Allan Gartner Wiring For

I have an S gauge MTH F-3A/B set. It has the latest DCS version The DCS system leaves a lot to be desired in terms of operating on my NCE DCC system Layout! Many of the functions operate differently

That has been a common discussinion for some time in the Trains.com forums. Not very compatible. Rich

No Apparently however - it is the other way around, with the ESU ECoS. https://www.youtube.com/watch?v=JJDefT8Udck I discovered that some DCC Decoders will not fully function even on their own brand

The 'banner' of the NMRA governs only the DCC signaling interchange to the track and a few particular CVs for normal but minimal operation. From there each manufacturer is free to invent and define

Back in the dark ages, our USGovt chose to force the auto mfgrs to standadise the shift quadrant on auto trans to put neutral between drive and reverse. Do you remember that? Well, the NMRA made a

I agree 100% Shame the computer people don't get it either Lee

THing is, development doesn't happen in a way that helps your view of it. There isn't a standards body that sets standards, after which everyone starts building the same stuff. What happens is that

Morgan and all.... https://www.youtube.com/watch?v=udyy2gQyNso Listen to this carefully about people going off in many directions. and NOT being Focused. ==== Apple was like this circa 1997 with Open

Hello all... I uploaded my Combination Layouts which together I have named the Betwixt And Between for I am also in an attempt to join them, using two Lionel Bascule Bridges, re-detailed to N

Mark, Are the two bascule bridges joined together when closed at a center pier? If so that would be an ideal place to use a centering pin on one side and a V shaped mating part on the other to ensure

On Sat, Jun 1, 2019 at 01:21 PM, Don Vollrath wrote: Don, Thank you for responding.... Are the two bascule bridges joined together when closed at a center pier? No not yet > But I have considered it;

Mark, If "the trackage for each layout is basically a simple single oval which with no turnouts. Then the Tracks simply meet over The Bridge with double track and continues to the next single oval.