Hi Jim, I've seen lift bridges done a couple of different ways. I don't know that there is any particular better way than any other. I'd worry about finding a good way to make sure that the rails on

Hi.. That is basically what I have used. I also decided to route the power so it cut off the tracks on both sides of the opening for 5 feet or so, which required (in my case) two switches. There may

Hi, Very soon I'll be laying track across two swing gates. Both gates are two levels of track. When a gate is open I want the track on the gate - and the approaches on either side - to be dead

This is a TEST message. Please DISREGARD. Do NOT reply to this test message. Thank you Allan

Hello All, I have a Peco SL-U8363 and (2) PECO PL-10 On the back of the Double Slip package They show one PL10 having Track Power IN To Right Hand Frog Track Power In the other PL10 To Left Hand

Here is an inexpensive Chinese solution that I have used: https://www.aliexpress.com/item/32899838442.html?spm=a2g0o.order_list.0.0.47521802qwpSoY Note that the 2-Gang option is the latching

E-Bay latching dpdt push button panel mount switch

try digikey https://www.digikey.com/en/products/filter/pushbutton-switches/199?s=N4IgTCBcDaIDYEMAuBjAFgSwHYHMAEADgK4DOaeARkUkgPZZ4kDuGqaApiSALoC%2BQA

Panel mounting these might be a challenge. Peace, Mike G.

Thanks Steven, Those will work. I was hoping to find similar switches with the more traditional red or black button. - Michael

https://protosupplies.com/product/latching-pushbutton-dpdt-switch5-pack/ Not sure if this is what you are looking for. -- Steven Tobias Sales Representative, Illinois Encision, Inc

Greetings, Does anyone know where to buy DPDT latching push button switches, preferably in bulk? Thanks, Michael Boyle

Hello All. The problem was I guessed wrong. The connector on the bottom of the turntable has no markings for A B C D and when working up side down it looks right but it was not. I flipped the Power

Jim, The turnout status will stay up to date as long as all commands are sent through a Power Pro via throttles/cabs or Mini Panels. They will get out of sync with a button board on a Switch 8, as it

Don’t really know much about this but why not try the effected engine on a test track not any pf the ones associated with the turntable or bridge. If that loco works on a test track then you

Hi Tom, The Walthers Cornerstone turntables have reversing built in. When wired correctly, you do not need an automatic reversing module. The key is wiring it right. Look at the diagram on my

Hello ALL, I removed the base from the layout and this time I marked the NO TRACK ZONES. and Home Base on the Lip of the base. Now I know where they are when it is placed on the layout. I reset the

Dave I flipped the wires on the bridge no change. Also according to the manual from Walthers they track has auto reversing already built in. I have a AR10 in stock but then if that was the case I

Tom, If you flip the wires on the bridge you would find the short circuit would go away until you rotate the bridge. You need an auto reverser added. David Klemm 12 PRO

I am installing a Walthers 90’ Cornerstone Turntable on my third level. I have the turntable placed. Leveled off. I have the wiring on the turntable done so my turn table now has power.