I have added a turntable AR photo for wiring comments by anyone. Thx

The following photos have been uploaded to the DBL XVR AUTO REVERSERS album of the w4dccqa@groups.io group. TT AR1 10-21-21 .jpg By: Lawrence Varady <mrmrsv5049@...>

Attachments, or embedded images, don't come through. Please post your image in the photos or files section, and tell us where it is. Thanks Blair Smith

Is this wiring correct for the dbl xvr shown? Any comments appreciated. Thx

Thanks Dave. I will look it up tomorrow!

Tom i use this product from azatrax for my reversing loops. Infrared sensors detect the train and change the polarity before the train crosses from the RL back to the mainline. It is slick. You can

I had a similar problem with a unifrog turnout, found the frog wire was touching one of the feed wires under it. Should have insulated the frog wire before installing it.

Tom, You used the word siding. Does it go anywhere else? If not, you can probably feed the siding from the same auto reverser (Tam Valley reverses) that powers the loop. Allan Gartner Wiring for

Hello All, I have one feeder for both loops Each Loop has a TAM Valley Dual Frog Juicer setup as a Auto reverser. The reverse loops are working fine. My question is On my one reverse loop I have a

Thanks Allan, Greatly appreciate all you do. - Michael

All, I have made a couple of additions to the Wiring for DCC Website: 1. Link to Evan Designs. They provide a wide variety of miniature LEDs useful to the model railroader. 2. The new Walthers DCC

See below. Blair Okay, so it reversed the outputs when you entered the section. Crossing the same gaps? Once they're aligned, nothing will change. But if you mean you are

This morning I went through all the steps verifying that the psx-ar is still working correctly. Then I rewired the frog on the left of the peninsula because I didn’t see it blink on the juicer. It

Charles You cannot do a reversing section with only one rail isolated. You MUST isolate both rails at all entry/exit points of the portion to be auto-reversed. If you've done that,

Charles, Both rails need to be isolated at both ends, so that starting from the switch into the loop you see: - track leading off it, left AND right isolated - continuous track until, before getting

I have the ar #2 section working now from the curve down through the straight side of the turnout on around the outside edge of the peninsula and up through the other switch. The inner loop in the

And yes, those would be the only two wires to the section.

I don't have one here, but that's the way I read the instructions on their website. Have you executed the test on page 3 of the manual?

I put a jumper J6-1 to J6-2 since I use NCE. THen I wired it and cut all drops from bus in that section. The lights weren’t on so I traced down a bad connection on the input side and it lit the 2

Charles There really isn't an answer - if you've truly isolated both rails of the indicated track, and each rail is only wired to one of the two outputs of the PSX-AR, and the PSX-AR is indeed