Hi Bob, Is your BD-20 before the PSX-AR? If so, that is your problem. The PSX-AR draws a little bit of power all the time and will cause the BD-20 to show the block as being occupied. If you are

Don This goes back to my question midsummer, "does anyone know of a solid state DPDT reverser that can be controlled externally?", because I have a large section(but not large enough to

Jerry, I agree lighting isn't that important, although I'd like to have it. Two other concerns: * My old Athearn passenger cars all came with wheelsets having one metal wheel and axle, and one

Good feedback van Henry DonV

I have an issue with a BD20 that is baffling me. See file "macionis BD20 question". I have a block running from point A to point B that is being detected by a BD20 at B. Originally all track from

The thread dealing with “Spacing between NCE BD20 detectors” has now exceeded 20 messages with very little in the line of a positive solution to the initial post from Bill Wilken on Sunday morning

The following files have been uploaded to the Files area of the w4dccqa@groups.io group. /macionis BD20 question.pdf By: Bob Macionis <macionis@...>

The following files have been uploaded to the Files area of the w4dccqa@groups.io group. /maconis BD20 question_000011.pdf By: Bob Macionis <macionis@...>

Al this may or not be new, but you may want to include it in the wiring peco Unifrog turnout section. The peco Unifrog has a wire to power the frog. The wire is not insulated and it is located very

Thomas, I’m new to all of this. The terminology I’m familiar with for powering track is main bus and feeds. Will the BD20 work properly with a feed where there are multiple feeds off of a main

Before starting my project, I set up a small test bed to make certain that I understood how to wire BD20s together with Atlas universal signal boards. The first thing it taught me was the

Notice what Alan said, ALL power for the track in the block must go through the BD20. I have three BD20 on the same module, about 3" apart on separate mainlines. Two work like a charm, one is always

Thanks, Blair. That seems like a solution. I'll have to reread the EasyDCC booster instructions. I think it says not to swap the two DCC signal pins to the booster. I don't know why that would be, if

Lighted rolling stock, passenger cars and other cars that need track power are a scourge to smooth operations. I am a curmudgeon, but when I weigh the need for lighted equipment on a layout that

Buy a creeper!

Do you have other BD20's connected to Atlas' universal signal control board in other areas of your layout that work? Just this one BD20 is not working?

Bill, The typical method for detection placement is for it to be on "the power to the block" rather than on "the power to one section of the block". I'll take the time to describe this further.

Definitely have 5 volts. On 9/27/21 10:24 AM, John Eldridge via groups.io wrote:

Thanks Bill, Based on your reply, confirming how this BD20 is connected, you said 3 wires: “one logic, one common, one power”. Have you measured the “power” voltage @ the BD20 terminals

Don, And yes, I realize you're not working with a Digitrax system, but the concept is the same. However the booster 'learns' what phase of signal to generate, you'll have to swap the