Re: WIRING TWO LEDS FOR INDICATION


Ed
 

Don,

OK, I figured out the issue - the voltage from the diode tester on the multimeter was not enough to drive the green led when hooked up in my multi-LED setup.  When I used 12vdc it works fine.  The red LED is brighter but I can adjust that with a resistor in the red leg but that is adding a complication I am not ready to take on.  By the way, I have uploaded a picture of the circuit I am using in the files section entitled "Tortoise Indication".

Ed Robinson

Join w4dccqa@groups.io to automatically receive all group messages.