DCC Track Design for review

Chuck Stiles

Hi I'm new to the group and DCC but not to the hobby
Its been over 30 years since I built my last layout (a lot has changed since then)
I have been doing a lot of reading & research. I designed a new layout 5 x 8'  the table is built and ready to go (you can see it in the FILES section) "Final Layout for Review" 
I am proficient with auto cad so after I tried some of the available free programs like Any Rail I decided to do it in autocad so I can get may track spacing and radius geometry correct.
I have Purchased Peco electrofrog turn out switch Peco 100 Flex Track its going over an old school cork roadbed and ballast
I have purchased tortoise switch machines as well
I built the Walthers Turntable and its ready for install
The uploaded drawing shows my proposed track layout with isolator locations track feed locations and block identification
I plan on wiring the elecrofrog thru the tortoise as per many online recommendations I have read  
The purchase of the other DCC controls I have not fully decided on, I am planning on building a fascia control panel for switch control as well as control from a handheld throttle. In the future I would like to experiment with PC control using JMRI software (but one step at a time).
I'm welcoming anyone to look at my plan and see if I may have over looked something thus far before a start making things permanent. 
There is a reversing section across the middle that I had concerns about wiring a reversing module

Chuck Stiles

Join w4dccqa@groups.io to automatically receive all group messages.