Re: edge connectors vs. terminal block

Vollrath, Don <dvollrath@...>

Puckdropper: A clever solution to add screw terminals to a Tortoise. Did you measure the angled hole-to hole pitch? What is it?
Some of the suggestions for alternate parts have different dimensions which may not fit.

-----Original Message-----
From: [] On Behalf Of puckdropper
Sent: Friday, August 03, 2012 9:09 AM
Subject: [WiringForDCC] Re: edge connectors vs. terminal block

I came across an interesting idea shortly after the edge card connector to screw terminal boards were released. Scroll down the the bottom of this page:

This would seem to make wiring under the layout easier, while maintaining a reasonable amount of reliability.

I've built one as a demonstration, but it's not been installed on the layout yet to see how well it works.

If you use screw terminals, be sure to look at the wire gauges and capacities. Trying to jam more wires under a screw than the device is rated for is a sure way to have problems.


Join to automatically receive all group messages.