Re: Need advice on wiring a cross-over and wye junction


David Penty
 

I inserted images under Photos but also under Files – I can delete one of them later.

 

David G. Penty

davidpenty@...

(416) 574-4557 ( C )

(519) 855-6961 (R)

 

From: w4dccqa@groups.io <w4dccqa@groups.io> On Behalf Of David Penty
Sent: May 2, 2021 11:44 AM
To: w4dccqa@groups.io
Subject: Re: [w4dccqa] Need advice on wiring a cross-over and wye junction

 

Thanks, Blair.   Beyond the small ‘Y’ is a very short space and then a double crossover begins which is managed by 2 MRC auto-reversers.   But, I’ll put up the diagram, as is, unless you think I need to show more detail of the mainline.

 

David G. Penty

Penty Photographic Services

myflyanddrive.com

davidpenty@...

(416) 574-4557 ( C )

(519) 855-6961 (R)

 

From: w4dccqa@groups.io <w4dccqa@groups.io> On Behalf Of Blair
Sent: May 2, 2021 10:17 AM
To: w4dccqa@groups.io
Subject: Re: [w4dccqa] Need advice on wiring a cross-over and wye junction

 

David,

You'll have to post the picture to the photos area here.  I saw your post on the Digitrax list.  You have two options:

1) The stretch from the crossover to the small 'y' could be fed via an autoreverser

2) The tail of the 'y' could be either fed via an autoreverser, or fed based on the position of the turnout (i.e. feed it from either leg, depending on the position of the turnout; that will require, likely, a relay or other electrical artifice).

I can't tell you which is more appropriate, as I assume your diagram is part of a larger layout.  If the tail of the 'y' in fact connects elsewhere, then the electrical 'state of affairs' may be more complicated.

Blair

On 2021-05-02 9:10, David Penty wrote:

Hello all

I’m new to the forum and still reading my way through Allan Gartner’s Wiring for DCC documents – excellent material.  However, I’m looking for some specific guidance

 

At the end of my mainline, I’ve re-laid track.  In the attached diagram, the turntable was pre-existing, but all turnouts and crossover are new.  I’m not certain if an auto reverser is needed and if so, where it would be located.  Can someone give me an idea of track wiring for the layout.    Peco suggest, on the package, that insulating all ends of the crossover shouldn’t be needed but then provide an example of how to insulate the crossover on all sides. 

I’m running Digitrax, Code 100 HO with Peco turnouts.

 

Incidentally, I got some gravel stuck in the Atlas turntable;  when I lifted the platter off, 2 pins with springs fell out.   There appears to be no way to replace the pins/springs when you invert the platter to install it.  Anyone run into this issue?

Thanks in advance for your assistance

 

 

David G. Penty

Penty Photographic Services

myflyanddrive.com

davidpenty@...

(416) 574-4557 ( C )

(519) 855-6961 (R)

 

Join w4dccqa@groups.io to automatically receive all group messages.