Re: Smail question
toggle quoted messageShow quoted text
I am building my version of the NMR Magazine Red Oak Line. I am using a PM42 to split the layout into four Power Sections. The Red dashes show where I have plastic Rail Joiners to separate the four districts.
On Tuesday, February 9, 2021, 6:07:06 PM CST, JoAnn Donaldson via groups.io <joannplano2005@...> wrote:
I will repost it. Thanks
On Tuesday, February 9, 2021, 11:16:11 AM CST, David McBrayer <d_mcbrayer@...> wrote:
I have not seen your drawing; not embedded in a message, nor in the 'Photos' folder for this group.
On 02/09/2021 8:45 AM, JoAnn Donaldson via groups.io wrote:
I hope you got my response to your request. I know the track layout is crude but it does represent my layout with the four Power districts.
On Monday, February 8, 2021, 5:54:21 PM CST, Bill Wilken <bill.wilken@...> wrote:
Thanks for your response. I hate to admit it, but after looking very closely at my wiring, I discovered that I had inadvertantly grabbed the wrong gauge wiring from my wiring bin when installing the main bus for the power district that was having the problem cited. As you know, thin braded 12 gauge wire superficially bears close resemblance to non-thin braded 14 gauge wire. While the 14 gauge wire that I had used is just too "skinny" to carry the DCC command signal to the Snail.
On Sun, 2021-02-07 at 13:50 -0800, David McBrayer via groups.io wrote:
Castro Valley, CA