Re: Protecting bus to feeder connections

David Klemm
 

Paul O’s method is the same I use. Off setting the connections is sufficient. Not like the buss wires will move!  :)

David Klemm
11 PRO Max


From: w4dccqa@groups.io <w4dccqa@groups.io> on behalf of Paul O <pomilian@...>
Sent: Sunday, October 20, 2019 7:53:56 PM
To: w4dccqa@groups.io <w4dccqa@groups.io>
Subject: Re: [w4dccqa] Protecting bus to feeder connections
 
Greg, I simply offset the solder connections to the bus by a couple of inches to prevent shorts. Since it’s under the table there hasn’t been a problem.

Paul O._,_._,_

Join w4dccqa@groups.io to automatically receive all group messages.