Re: Powering Hinged Point Rails
toggle quoted messageShow quoted text
Assume by "a 24-ga. solid wire soldered from the web of the point rail to the web of the frog rail," you mean "to the web of the stock rail"
Isn't stranded wire (if not what I suggested more flexible though? But what works, works!
On Friday, March 1, 2019, 8:17:39 AM PST, Swanny <john@...> wrote:
Jerry, I have modified about 130 Walthers Code 83 DCC-friendly turnouts in the last 3 years. Every turnout has a 24-ga. solid wire soldered from the web of the point rail to the web of the frog rail, across the rail joiner. This is done to avoid the eventual failure of the electrical contact between the stock rail and the point. The process includes burnishing both solder points on the rail with a small wire brush, coating both surfaces with flux, tinning both surfaces with solder, and similar preparation of the wire. The final step is to connect the wire to the rails using a conical tipped iron that has been properly tinned. Although this results in some stiffening of the point action, I have had no problem activating them with Tortoise devices. Note that I use a heavier gage wire for activation than is supplied by Circuitorn, mostly due to my 11/16" plywood + 1/2" Homasote + cork base, but it also takes care of any stiffening of the point action.
I hope you find this information helpful.