Re: Wireless DCC tether between steam engine and tender TAM Valley

Glenn
 

I briefly glanced Pete's page.

Note that the Tam Valley line has been taken over by Dead Rails Installs -- http://deadrailinstalls.com/

The Tam Valley DRS1 system is not a control system, but a system the sends signals to a receiver that in turn sends them to the decoder via R/C. A transmitter is attached to the output of a DCC base station that sends wireless signal to a receiver which in turns sends them to a decoder.

Glenn

-----Original Message-----
From: "davidghorn@... [WiringForDCC]"
Sent: Dec 19, 2017 10:49 PM
To: WiringForDCC@...
Subject: RE: [WiringForDCC] Wireless DCC tether between steam engine and tender



Thanks for the clarification on RailPro.  I should have referred to the web site shown below write up on the different systems.  I read it over the summer, but forgot a few things since then.  Lots of useful battery powered ops info if you haven't read it before, check it out.  

Dave

Join w4dccqa@groups.io to automatically receive all group messages.