Arduino IDE Shakti not working with Win10. Why?

How to solve this error ? .platformio\packages\framework-shakti-sdk@0.0.0-alpha+sha.5880320115\bsp\core\start.S:38: Error: unrecognized opcode `sila t0,trap_entry' *** [.pio\build\parashu\bsp\core\sta

c:/.platformio/packages/toolchain-riscv/bin/../lib/gcc/riscv64-unknown-elf/8.3.0/../../../../riscv64-unknown-elf/bin/ld.exe: error: .pio\build\vajra\bsp\drivers\libclint.a: file too short collect2.exe

Hello Everyone, Your sample code "hello world!" work on my parashu. But I observed following idiosyncrasy that, I have to repeat "openocd ... " command second time for code to run on Shakti displaying

I tried uploading the following code using gdb to my vajra. #include "uart.h" int main() { printf("hello, world"); return (0); } However, i got the following error when i tried to specify the linked f

We are trying to compile and upload hello.c in artix-7 35t model using Win10 and VSCode(Platformio). ref: SHAKTI on Platform IO (VS Code) - Windows 10/Ubuntu 18.0 What works: 1) Code is built successf

Hi, Thank you all for participating in the Swadheshi microprocessor challenge using Shakti processors. It has been a wonderful journey, from the time the challenge was announced till the finals. Your

We have purchased Artix-7 35t from element14 with micron as the manufacturer. We have done the same process as insisted in the videos. Instead of spansion choose micron in the vivado and programmed mc

I am getting error messages when uploading bigger code to shakti pinaka using arduino ide. Error message during compilation: Converting elf to hex elf2hex: ../fesvr/htif_hexwriter.cc:40: virtual void

Username : Vignesh Durai Email ID : dvignesh5@... Requesting GIT-LAB Access

Sir we have developed an application under shakti-sdk/software/projects which runs fine in debug mode and the expected output is also obtained. But when I try to make it standalone by using make uploa

When we are running the code in debug mode we are able to get output as expected. We are interfacing VAJRA with ESP32 in our solution via the UART interface and we are able to perform RX-TX properly i

Dear sir, I try to upload code in shakti pinaka using arduino ide.When the code size exceeds 66800 bytes,the code is not uploading on the board.Then i made change in line 37 in elf2hexspansion.sh file

when we run riscv32-unknown-elf-gdb on the terminal we are getting a message that No such file or directory.

Hello, I'm stuck at this error since few weeks, please guide and help as semifinals are on the way. I've attached the screenshot please check. Thanks

Hello, while reading the UART when we read the uART for second time in the same code we want to flush recieve reg before reading new output, we are trying to use Flush uart inbuilt function but someho

Hello, We have bought ARTYA-7 FPGA Board from Digilent, We want to run shakti Vajra SOC on it, can we get guidance for the same?

We're getting this error since long, please see the Screenshot attached. We aren't able to rectify this, even after having followed the steps given in the user-manual for the OpenOCD installation. We'

Dear sir, I try to upload code in shakti pinaka using arduino ide.When the code size exceeds 66800 bytes,the code is not uploading on the board.Then i made change in line 37 in elf2hexspansion.sh file

Hello, I am working how to simulate exceptions on risc v. I have found shakti manual but this example does not work for me. Do you have any ideas how to do "Instruction access fault" in other way than