Afternoon Graham. As Den says, use the blue selections at the end of emails. Or - When signed in to the SDARC groups.io web page you should see the option to create a new topic in the left hand panel.

I'd like to see the EMF requirements for this setup! Only in America! He clearly thought his Yaesu FT-817 was a little under powered. https://www.youtube.com/watch?v=Nxp_Nsa54_Q 73, Dom, 2E0WHQ

Didn’t do a major attempt because I hadn’t managed to get a decent low band antenna or a beam up. Went for 40m single band, HP, unassisted. Had to use the Cushcraft R7, a 40m to 10m vertical but did h

So, at stupid o'clock this morning, the council turned up outside my property to change the street lamps over to new LED lighting. They changed the lights at both the front and rear of my property. Th

Here is a video from last weeks BATC CAT21 on microwave EMF calculations. https://youtu.be/IZFsf3B3EO4

Following on from this evening's excellent presentation by Den, I thought I'd have a look at the latest RSGB EMF calculator (version 11), which can be downloaded from here: https://rsgb.org/main/techn

For those of you that have a pump up mast but do not subscribe to The RSGB Technical Forum on groups.io, you may wish to read this long and growing thread: https://groups.io/g/RSGBTechnical/search?p=%

Morning All, I am in need of a copy of the circuit and PCB layout of a TS120.. I can find some copies on the net but the PCB overlay is not clear enough. So a hard copy of and original service manual

Hi all, A few weeks ago I considered designing a project to control my IC9700 voice memories. Before embarking on a new project I always check if someone has already done it first. The obvious contend

There is a planned Parish Council meeting at Pinetrees on Thursday. WE will therefore be back in the Meeting Room, upstairs. Car park as normal, then use the side gate to go to the front door (on Pine

A bit of "light" reading. Hypothesizing that the location of the Aircraft can be aided by using WSPR. Best of luck understanding it! https://www.dropbox.com/s/7z96vl8oicybpcy/AMSA%20MH370%20SAR%20RNZA

Hi all, I’m delighted to have just achieved my first 100 LoTW confirmed DXCC entities – yes, it’s the Mixed category and most are by FT8, but, hey, it’s a start! I’m now starting on ARRL’s tortuous pa

Thought I would mention it for those interested and not already aware anyway No sign yet, but the rumour mill says this is imminent

Hi everyone, Has the October issue of RadCom been received yet? I'm sure I've usually received mine by now. Many thanks and 73 David G7IXU

Hi. Does anyone have access to or know where I can hire a metal detector.?? I need to locate a manhole cover on a rear garden. Unfortunately it’s under decking and a heavy duty anti-weed net, so hopin

Hi All, We're trying to trace the source of a pulsing signal in Swindon on 430.350Mhz. It's continuous pulsing and 'pip' tone, which can be heard all around Swindon. If anyone has a beam up for 70cm,

It was great to see so many Members back again at Club tonight for our first get together. We were just shy of 30 attending AND (thanks to Phil, Jonathan and Dom) we also had a station on the air! Bec

Hi Gents, Are there any thoughts about the first night at Pinetrees? New members and recent joiners will need some kind of walk through or introduction, I would have thought. I could help with that, i

Good morning SDARC Members. No, you are not having a flight of fancy ! There is no typo in the subject line !! SDARC WILL be meeting again at Pinetrees Community Centre from THIS THURSDAY 9th Septembe

Hi, Does anyone know where one can source one of those drive-on mast supports? I am planning on doing some portable work and need something to support my pole, as it were. Any info appreciated. 73 Phi