Hello Folks, Here are some details about the logic of hole milling: If the hole size is smaller than the endmill, and between the endmill's minimum and maximum as set in the rack file, the endmill is

#pcbgcode #drill #helical

"Properly" generated code from eagle runs ok as a dry run but as you pointed out it has all the initialisation features needed to work wrapped round the actual code. Probably a bit naive of me to expe

#pcbgcode #drill

HI Peter, After some mishaps with very small vias (Well, in truth, too small) I was advised that it is better to drill first, then etch. Doing it this way eliminates a need to spot-drill, although I s

#drill #etch #gcode

Hello Dave, John, I tried to find the github repo you, John, referenced in your second post above, but without luck. Is there any progress on this topic? Thanks! Harry

#drill

Many thanks for the help, Y?es the problem was the interface from my chair to the PC. After resetting the zero all worked on. Again thanks for putting u[p with my incompetence. Vaughn

#drill