I thought I was asking about swarf.

What step size do you use and what cutter diameter? I’ve found if I use a step of >=50% the cutter foam, I get these “leftovers”, but, if I set a step of 30-40%, it tends to be clean. Takes

HI Dan, I've been cutting my "grooves" in a single pass. I'm assuming "steps" means offsets, maybe cutting a groove and then making another pass .001 nearer the trace to clean it up. Is

Yes, that’s the idea. I got tired of cleaning the grooves myself. John T. Johnson PhD Candidate - Cognitive Motor Control Laboratory Lab TA NEURO 2001 Principles School of Biological

sounds like the old shampoo ad. Cut, repeat. While I'm at it i want to again thank you for your wonderful code. As I wrote when I first surfaced the swarf problem, I've gotten

Hi Bruce, If its any help this is what I have done in bCNC for laser work: I have added 4 user defined buttons on the control tab:- Laser mode on; $32=1

Thanks for the info Marcus, I will give that a try. Bruce --------------------------------------------

Glad to hear everything is working, John. Maybe one day I’ll get back to it… Regards, John T. Johnson PhD Candidate - Cognitive Motor Control Laboratory Lab TA NEURO 2001 Principles School of

In bcnc there is a new complement (I do not know if it is already available) to clean the traces of pcb with laser (remove black paint for acid later) which I have helped with my small contribution

sorry if I return with the same theme: it is useful to use your software to generate the trace layout with a bit of 0.10mm and then increase the separation between tracks with a bit of 0.7mm. Can you

No entiendo. Que quieres saber?

The person who posted the first message in this thread has been banned for continued attempts to discuss hacked/cracked software.This forum does not support discussion of pirating or pirated software.

No, but you will need to go back and try to match the version of the board file that doesn't have your changes. In Eagle, you cannot change the board without changing the schematic and vice

I liked idea of running same bit a second time. I'm going to try that. thanks for your thoughts. john

Mine worked just fine in win10 as "C:\EAGLE-9.3.0" after i elevated all permissions for that folder (including subfolders). But i like the solution of putting the files in server and i think i will go

I have been using optimizer "Optimizer for PCB Gcode. By Daniel Purvis and Jay Couture Version: 1.1 Releases 8/1/2008" But it doesn't work anymore. It brings up a dos box with the input and output

https://github.com/pknoe3lh/cncgcodecontroller

I have a version from 12-8-2008 for you!! (0_1_7) Roel Op vr 19 apr. 2019 om 19:34 schreef Patrick <pknoe3lh@...>:

But this would require changing the control hardware on my mill. I am not that desperate yet!

Terrific! Where do I get it, can you upload files on here?