Re: Best size end mill for milling perimeter of PCB? #mill

Dan.Staver
 

Sorry, I missed that fact :-)

I use precisebits.com router bits for routing perimeters and internal channels. https://www.precisebits.com/


Dan Staver
Tave Tech Corp.
3130 Hollycrest Dr.
Colorado Springs, CO 80920
+1-719-359-5352 - office
+1-719-502-1675 - cell
tavetech - Skype
dan.staver@...
www.tavetech.com
W3QDO

On Dec 22, 2019, at 3:13 PM, keith3125 via Groups.Io <kc1of36@...> wrote:


He was asking about cutting the perimeter.

On Sunday, December 22, 2019, 05:08:44 PM EST, Dan.Staver <dan.staver@...> wrote:


I use the largest size bit I can while keeping it 2-3 mils smaller than the smallest gap between traces.

Dan Staver
Tave Tech Corp.
3130 Hollycrest Dr.
Colorado Springs, CO 80920
+1-719-359-5352 - office
+1-719-502-1675 - cell
tavetech - Skype
dan.staver@...
www.tavetech.com
W3QDO

On Dec 22, 2019, at 3:05 PM, keith3125 via Groups.Io <kc1of36@...> wrote:


On Sunday, December 22, 2019, 05:00:35 PM EST, Terry Gray <twgray2007@...> wrote:


Maybe a bit off topic but can someone recommend the best size and type of end mill for milling out the perimeter of a PCB?

Join pcbgcode@groups.io to automatically receive all group messages.