Re: What an I Missing - Eagle Question? #eagle


That being the case, maybe switching off  Snap to Grid in Eagle will allow it do it properly for you.


Just a thought


73….Eric VK2VE


From: <> On Behalf Of John Ferguson via Groups.Io - at
Sent: Monday, 19 November 2018 12:40
Subject: Re: [pcbgcode] What an I Missing - Eagle Question? #eagle


This is very close to what I'm using in Imperial.  I need to check the pcb-gcode, but I don't think it is where my problem is. I can see the traces too close to pads in Eagle. Moving them manually does fix them. 

thanks much,


On 11/18/18 4:23 PM, Chipteck wrote:

I am sorry, I didn't have a lot of time and was too quick to respond.
In any case I am loading "20170624 -pcb-gcode.dru" file on my projects to setup my clearances and have been successfull to cut 0.2mm traces with 0.1mm clearances with the following:
pcb-gcode setup - Generation > Minimum = 0.03mm, Maximum=0.2mm, Step size=0.05mm - Machine > Tool Dia = 0.1mm



Join to automatically receive all group messages.