Re: Can only get a single isolation pass around tracks #eagle #pcbgcode #etch

peterg1000
 

Took your board and erased all your tracks and polygons, then set all the tracks to 0.4mm in "net classes" and all clearances to 0.4mm in "design rules". Ran the autorouter and chose the minimum "vias" solution.  Then ran pcbgcode with my own default settings and a 0.2mm 30degree engraving tool.

Examined the results using UCCNC toolpath display, and took the attached screenshot for your info. Note that there are some nets not routed, but you get the flavour of the results.

Peter

Join pcbgcode@groups.io to automatically receive all group messages.