Re: Autoleveler on tb6560

Dan Andersson
 

Again,


Use the Feed command "F3" and not the "x3". Where did that come from? Did I make a typo earlier?




//Dan


On Mon, 23 Jun 2014 19:45:29 -0600

"Ivan de Jesus Deras Tabora ideras@... [pcb-gcode]" <pcb-gcode@...> wrote:

The command "G38.2 Z12 x3" will allow you test your configuration. If
everything is fine the Z axis should stop when it the tool make contact
with the copper surface. But remember first to change the configuration
for pin 15 to "Probe In" not "Home Z". Look at this screenshot, pin 13 is
configured as "Probe In".

http://forscience.nl/wordpress/wp-content/uploads/LinuxCnc-stepConf-Wizard-parallelPort-screen.png

Regards,
Iván


On Mon, Jun 23, 2014 at 7:29 PM, theguytrain1@... [pcb-gcode] <
pcb-gcode@...> wrote:



in order to probe in I need to use test command like the way you explaint
my before ??
with the G38 z12 x3 "G-code"??

Join pcbgcode@groups.io to automatically receive all group messages.