Re: Autoleveler on tb6560

Ivan de Jesus Deras Tabora
 

The command "G38.2 Z12 x3" will allow you test your configuration.  If everything is fine the Z axis should stop when it the tool make contact with the copper surface.  But remember first to change the configuration for pin 15 to "Probe In" not "Home Z".  Look at this screenshot, pin 13 is configured as "Probe In".



On Mon, Jun 23, 2014 at 7:29 PM, theguytrain1@... [pcb-gcode] <pcb-gcode@...> wrote:
 

in order to probe in I need to use test command like the way you explaint my before ??
with the G38 z12 x3 "G-code"??


Join pcbgcode@groups.io to automatically receive all group messages.