Date
1 - 3 of 3
Auto Buttonhole Not Working
|
dmrestates
I have MC10001 that has been a workhorse. The embroidery is absolutely beautiful and the ordinary sewing has been flawless until today. I put the auto buttonhole foot on and pulled the lever down and the button in the slot. It sews the right side and the end part perfectly, but when it starts sewing the left side, it does not stop but keeps going past the place where it should stop. Any idea what could be wrong?
|
|
|
|
First make sure that you chose the automatic buttonhole. My memory of the 10001 is not as good as it was - OK, let's be honest. My memory is not that good for anything! That's why I can happily watch the same TV show 8 times and it's always new. But I think there is one of the buttonholes that sews in one direction until you tap a button to reverse it, and again to stop it. Check the manual on that. Otherwise the sensor may need a bit of adjustment. It's not a difficult procedure, but your dealer will have the information on how to do it. Should not be expensive.
|
|
|
|
dmrestates
Thank you. I will double check. You are correct that there is a manual way of doing the buttonhole and that is what I resorted to when this happened. My mind isn't what it used to be so I will try again paying specific attention to being in the auto buttonhole feature. I think a trip to the dealer over an hour away is in my future. Sent via the Samsung Galaxy S9, an AT&T 5G Evolution capable smartphone -------- Original message -------- From: "Jim Stutsman via groups.io" <onlinesewing@...> Date: 6/7/21 10:03 PM (GMT-05:00) To: onlinesewing-janome@groups.io Subject: Re: [onlinesewing-janome] Auto Buttonhole Not Working |
|
|