Number 3. 🌹🌻🌺🍄🌼🌞🌙🌏❄🌈⚡☁🍃🌷🌸💐🐎🐬🐟🐄🐏🐝🐛🐌🐥

#poll

Thanks you so much for asking for input re new videos 😊. My trouble spot is Stitch Composer, I just can’t seem to “get it”. But perhaps I just need to keep going over already existing lessons 🤪.

Just thought I would add that it was a Sew4Home project. So it was using all Janome machine & feet. And their instructions with photos definitely show them sewing through even more layers than what I

Oh my goodness, thank you for all the feedback on this needle judder thing, sort of good to know that others have also experienced it. Perhaps it does that to prevent a major needle break. I shall cer

I was sewing a loop, onto a tortilla warmer that I was making, so it was going through about 14 layers of cotton + wadding, when the needle juddered & I didn’t force it any further. I think the needle

Thanks so much for that explanation of “handles” Barbara, now I understand! Makes perfect sense - I have learnt by experience that it is best to use the corners to resize without distortion but never

Thanks for that clarifying that. The website is OESD which is affiliated with Janome hence why I was confused by the message which appears in all their instructions/info about a design.

I need clarification as to just what this message (& various forms of) means - “To preserve design integrity when rescaling or rotating designs in your software, use the handles on the screen” ... ? D

That did the trick, can see & click the Wiki now! Thanx.

There is no ”Wicki” in my left hand sidebar ... ??? I am logged in.

Here is a screenshot ...

I am also a bit bamboozled by the simple act of trying to sew two pieces of say water soluble stabiliser together with zigzag (& water soluble thread) - one side will feed at a different rate to the o

Gosh, great tip Ceil, thanx for that! I’ll definitely give it a go 😊👍🏻

Yes I’ve used the AcuSetter app but couldn’t use it for stitching on a towel as it covered the black marks on the hoop.

Thanks for the reminder to calibrate the hoops, I last did it over a year ago. However my frustration is with AcuDesign showing the centre of the sq14 hoop as being about a centimetre below the actual

Thanks for that ... I can see the fit to hoop button but not a centering button ...? i just checked the SQ14 hoop again & yes it’s own plastic template does line up with the plastic notches for Center

Hahaha, more fool me, I have just remembered that the centre is not necessarily equidistant on the different hoops. But I still can’t work out why the design wasn’t centred ... no doubt due to operato

I was most perturbed today to find that my embossed design on a towel was not centred as I had been so careful to check before stitching. I just couldn’t work out what had gone wrong so I checked all

I have had a problem arise after using the AcuSetter app - the 15000 touch screen responses became very slow & took numerous attempts. It was only resolved by powering right off & on again. Has that h

Well I had finally managed to get a huge towel correctly aligned in the hoop & it was wizzing along at 800 spm. I was sitting in the living room when AcuMonitor said “Lock!” So I went to investigate -