Thank you Pixey I will check that out. Fiona

Yes it is and i do not understand why the dealer close to me services everything except the 15000. Thank you for the suggestion i will look into that but i would still like mine to work.

Maybe you can embroider the buttonholes. I've seen free buttonhole designs online. Kathy 3-4 hours to your dealer is a nightmare!

Fiona, You might see if you can get the B2 Automatic Square Button Hole (page 48 of the 15000 v2 manual). It does not require pulling down the buttonhole lever. Pixey

Hi all I am desperate. I have 9 projects for Christmas that all need buttonholes and I can't get my 15000 to do them. It kept giving me the error message "pull down buttonhole lever" but the button

I just had a similar thing happen to me, not on an embroidery machine however message was the same. It was a brand new machine! I called and took it right to Janome headquarters in Oakville, Ont and

Always nice when it works out that way…have had that happen myself. 😁. Glad there’s nothing wrong. - Cat Typos courtesy of autocorrect.

I had similar with my 15000, I was terrified! I put a new bobbin case in as my original had been punctured with a needle strike, I filed it and it was working fine but I wanted a new one, so replaced

I dislodged the bobbin case and it works!!!

That's why you got the message. The bobbin case either got spun past the stopper, or was lifted up by thread being out of the take-up lever so it jammed. Remove the thread. Then turn the hand wheel

Thanks for your quick reply. When I went to take out bobbin case, it seems to be stuck. What is the best way to remove?

First shut your machine off. Let it rest a few minutes. It is possible your arm has something stopping it. It sounds more like your embroidery arm making the noise. Before turning back on check your

Remove the needle plate and bobbin case. Turn the hand wheel through a couple of stitch cycles. If it is hard to turn, it may be a bushing failure which will require dealer intervention. If it turns

I am trying to embroider on my Elna860(same as Janome9900) when I start the embroidery, the machine stutters, I get an error message, and it will not sew. the error message is "is anything stuck in

Many software programs have features, such as adjusting stitch density, that improve resizing above/below 20%. - Cat Typos courtesy of autocorrect.

I have a friend that uses Embird and loves it. She says that she can resize a design more than 20% with no problem in Buzz edit (I think). It was one component of the program. Kathy

Thanks, Lyn. Good to know.

Oh my goodness! That was a few years ago wasn't it!. I still follow all the conversations but only put in my two cents when I actually feel I have something new to add.

Kathy I have Embird and Embrilliance. for resizing and editing., Both are very comprehensive. Embrilliance offers 12 free lessons to get you started. In my opinion, for resizing and editing Embird is

No it won’t hurt the machine, if it doesn’t read the format it just won’t show it. I’m fairly sure the 350 will read it, can’t remember if I’ve used it on mine.