Date   

while embroidering machine stops after 10 stitches

Lynda Lu Gibb
 

Set up a new design and began stitching, but the stitching stops after about 10 stitches, then I need to push the start button again.. no message on the screen to indicated why..any suggestions?


Re: Janome 15000 cabinet

Anne Parker
 

I don't have a cabinet for my machine.  I use a BEKANT desk from IKEA.  It's part of their office furniture range and can be raised and lowered as needed.

I bought the largest size 160cm x 80cm (72 in x 32 in) with oak veneer top and white legs, with manual adjustment for £150 https://www.ikea.com/gb/en/products/desks/office-desks/bekant-desk-oak-veneer-white-spr-39022807/- but you can get more expensive versions that have electric adjustment.

I have mine set at the lowest height of 65cm - about 26 in (which puts the machine sewing surface at just the right height for me being short) but it can go up to 85cm - about 34 in - the electric sit/stand versions will actually go to a height of 125cm (50 in).

They also have a 10yr guarantee and are very sturdy.  I have mine on carpet and don't have any problems regarding vibration.

Anne
www.sewingtales.wordpress.com

https://www.flickr.com/photos/94302460@N03/sets/

"Great dancers are not great because of their technique, they are great because of their passion"  Martha Graham


Re: Janome 15000 cabinet

Caroline Wright
 

Thanks for all the suggestion, very helpful.


On Apr 10, 2019, at 5:02 PM, Sandie Williamson <stitchin211@...> wrote:

Your dealer should be a big help. When I got my 15000, I bought its table at the same time from the dealer & have been so pleased that a later decision wasn't required. Good luck with finding that perfect solution.

On Tue, Apr 9, 2019, 8:39 AM Caroline Wright via Groups.Io <grannygeek4=aol.com@groups.io> wrote:
I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Re: Janome 15000 cabinet

Sandie Williamson <stitchin211@...>
 

Your dealer should be a big help. When I got my 15000, I bought its table at the same time from the dealer & have been so pleased that a later decision wasn't required. Good luck with finding that perfect solution.


On Tue, Apr 9, 2019, 8:39 AM Caroline Wright via Groups.Io <grannygeek4=aol.com@groups.io> wrote:
I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Re: WiFi Connection

Jim Stutsman
 

An IP address is four numbers, separated by dots. Your machine's IP must have the same first 3 numbers as the computer's IP in order to be found. Some routers support a "guest" network, which allows visitors to use your network without having access to your stuff. It's possible that the machine is on a guest network, rather than the computer's network. If the IP numbers match (first 3), then the WiFi antenna may not have been reconnected after the A board replacement. Your dealer should be able to take care of that. Before leaving the store make sure that your machine can be reached on the dealer's network. Hopefully they have one.


Re: Janome 15000 cabinet

J Fraker
 

I ordered the Sylvia Design Model 2600 from Sewing Machines Plus.  I LOVE it!  It fits the big machine perfectly, is very easy to raise and lower, the height is adjustable, and I got the optional cabinet insert that fits under the drawer on the left side.  I have tons of storage space and the rear leaf lets me handle large quilts with no problem.


On Tue, Apr 9, 2019 at 8:39 AM Caroline Wright via Groups.Io <grannygeek4=aol.com@groups.io> wrote:
I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Re: Janome 15000 cabinet

Betty S
 

I have had the Horn Superior cabinet for a few years now. When I bought it I was told it was the only Horn that fitted a 15000. I have been very pleased with it.
Betty


WiFi Connection

Gail
 

I picked up my machine from having service yesterday and the A board was replaced.  When I set it up, I had to reconfigure the wifi settings.  No problem. I did it as usual and got the notice that I was connected to my network, but my computer cannot find the machine.  Now, the computer is right side of the machine and worked fine before.  I'm showing 3 bars on the machine and hadn't had a problem in the past.  I tried a number of times with no luck.  I searched for my network again and redid the whole thing with the sane results.  I rebooted my network and still no change.

Now, this worked perfectly before so I'm thinking I'm missing something.  Any suggestions?

Thank"s

Gail in FL


Re: Janome 15000 cabinet

Jollyne Toste
 

Hi Caroline,
i finally got a Koala table, with hydraulic lifts.  It has great storage and a huge work surface. You can order it in several different heights. I’d recommend the 35” it saves your back when cutting or pinning Quilts. 
Hiwever you should be able to contact any company to get specs and ask if the Giant Janome will fit.  Good luck and happy shopping.
a good table is worth the $$.
Jollyne
walnut creek, Ca


Re: iron cleaning

Maria Morrow <mariamorrowquilter@...>
 

I have found that the base of the iron affects what comes off easily. With my cheap $10 iron with a coated plate (not shiny steel), I heat I up, then as it is cooling, when it’s still quite warm but not cold, I use a wet Magic Eraser and everything comes off. With my also cheap, but $30 iron with a stainless steel plate, it took the whole house worth of solutions to get scorched starch off of it. 

Maria Morrow, Treasurer
Camellia Quilters
Mobile:  985-640-5024

On Apr 6, 2019, at 3:59 PM, Lyn Quine <lynquine@...> wrote:

They say rubbing the base of a warm/heated iron with a paracetamol tablet , use a cloth obviously, in the States it would be Acetaminophen.  It helps to remove more than just headaches!  Lol


Re: Janome 15000 cabinet

juliadlf.ny@...
 

I have a Horn but different model. 
If you go to the Horn of America website and do a search for the model you are considering it should list
under features the opening for the machine. 


Re: iron cleaning

Atemkeng Denis <denatem@...>
 

Apply wet baking soda on the bottom of the iron (warm) and leave for sometime. Then wipe it off with a soft cloth.
Denis


On Tuesday, April 9, 2019, 10:20:22 PM GMT+3, <bhd02@...> wrote:


I can remove most gunk on a hot iron with a wad of waxed paper. Just be careful with your fingers.


Re: iron cleaning

bhd02@...
 

I can remove most gunk on a hot iron with a wad of waxed paper. Just be careful with your fingers.


Re: Janome 15000 cabinet

Caroline Wright
 

Thank you Jean, I will take a look at them.


On Apr 9, 2019, at 9:30 AM, jeanbean48 via Groups.Io <jeanbean48@...> wrote:

Hi Caroline,
I purchased a sewing cabinet from Eddycrest and my 15000 fits beautifully. It has great storage for thread, hoops and so much more. I chose the centerpiece xl model so my machine has ample room and it holds up my quilts with extra space behind the machine. I love mine and l am glad I got it.  Eddycrest.com 
Jean


On Apr 9, 2019, at 7:37 AM, Caroline Wright via Groups.Io <grannygeek4@...> wrote:

I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Re: Janome 15000 cabinet

jeanbean48
 

Hi Caroline,
I purchased a sewing cabinet from Eddycrest and my 15000 fits beautifully. It has great storage for thread, hoops and so much more. I chose the centerpiece xl model so my machine has ample room and it holds up my quilts with extra space behind the machine. I love mine and l am glad I got it.  Eddycrest.com 
Jean


On Apr 9, 2019, at 7:37 AM, Caroline Wright via Groups.Io <grannygeek4@...> wrote:

I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Janome 15000 cabinet

Caroline Wright
 

I'm looking for recommendations for a sewing cabinet for my 15000.   I like the Horn 9000 but can't figure out if my Janome will fit?

thanks,
Caroline


Re: Bobbin cases, now Pre-wound bobbins

Jim Stutsman
 

The Janome packaged pre-wound bobbins can certainly be re-used when empty. However they are not the same as the 102-261-103 bobbins that are infused with rubber, and are stamped with a J on the stem. The pre-wounds are a bit thinner, probably so they can hold more thread. I think they are made with the idea that they are disposable, so Janome spends as little as possible on them. While they are not as robust as the standard bobbins, there is nothing wrong with re-using them. There's also nothing wrong with chucking them in the recycle bin, though I'm not sure that type of plastic actually recycles. As a child of Depression-era parents, I am quite attuned to wasting nothing. I vividly remember my maternal grandmother washing out empty plastic bread wrappers to use as plastic bags. My mother-in-law had a collection of bread wrapper twist-ties, neatly straightened and sorted by colors on a shelf in her kitchen. This sort of behavior affected both Diane and I, and we have been frugal as a result. We started out with nothing, and we still have most of it left.


Re: Bobbin cases

Lyn Quine
 

Would love to buy Janome prewounds, but not available in the UK, to buy from the states would cost in handling charges import and VAT.


Re: Bobbin cases

Cheryl Paul
 

Hi Elizabeth,

Embroidery Library and Embroidery Designs (2 separate sites) have nice designs at a reasonable price. I’ve also got designs from Sew Swell, Zundt, Sue Box and others that are well digitized and very nice but a bit more money. Just use “Mr. Google”, you’ll get so many sites. It is best to purchase ones that are JEF format, however, many come in all the formats and you just pick out the JEF ones to stitch out. Remember that the stitch limit is 200,000 stitches on the 15000, but most of the designs don’t reach anywhere near that amount, so it shouldn’t be a concern unless the design is bigger than the hoop size for the machine. The 2 things to watch are stitch count, and the size of the design and of course the format as well.

I found it difficult to read your post as you typed it all in upper case letters - that makes it look as if everything you are saying is VERY important - Just an observation. However, we like to hear from everyone no matter how you type. I worked as a typist so I find it easy to do, but not everyone does.

Cheryl - Saskatoon


Bobbin

JoAnn Novak
 

 I also use my empty prewound bobbins over & over.  Never have a

 problem.       JoAnn

Life's biggest decision is what you do with Jesus.

Narda,
I use my Janome empty prewound bobbins over and over;  that may have just been one weak bobbin.  
Maybe you could try again and if it happens again then talk to your service tech; I don't know but Jim would if there is such a thing as the bobbin winder making everything to tight.  

But I wanted you to know that I do use my bobbins over with success.

Pat 

On Mon, Apr 8, 2019 at 8:22 AM Narda Poulin via Groups.Io <nardapoulin=yahoo.ca@groups.io> wrote:
I would think twice about using them twice I did that and after I had filled the bobbin as I was trying to put it in the case the side of the bobbin broke off in my hand so it was useless as well as all the bobbin thread on it....it could have been just a fluke but I only use them once...anyone else have that happen?


6321 - 6340 of 30617