1. Nbems
  2. Topics

Windows 10 FLRig Config File

Ben S (KB0ZOM)
 

Hello,

First post here. I am trying to run separate configurations of flrig for each radio-not simultaneously just separate at the moment. I saw there were a couple posts on this subject. I looked at the section of the FLRig manual that talks about "--config-dir <target-dir>" and changing file names/targets. I have tried changing the filenames and the target as indicated in the manual, but each time it reads/writes to flrig.files in my user directory. I haven't been able to get the right format for --configure. It just gives me an unrecognized command error. Probably missing the obvious here, but any thoughts?

Thanks,
Ben KB0ZOM
Jim
 

Ben,

You might get some information in this group, but you probably will find more information and some useful information at: Support group for Windows users of fldigi: Join 'winfldigi' at groups.io.  NBEMS is a somewhat general name for the entire fldigi suite of software.  There are support groups for operators that use almost any type of computer operating system; Windows, iOS (or Mac), and Linux.

Good luck in your quest.

James Good kd5vxh

On 10/31/22 12:30 PM, kb0zom@... wrote:

Hello,

First post here. I am trying to run separate configurations of flrig for each radio-not simultaneously just separate at the moment. I saw there were a couple posts on this subject. I looked at the section of the FLRig manual that talks about "--config-dir <target-dir>" and changing file names/targets. I have tried changing the filenames and the target as indicated in the manual, but each time it reads/writes to flrig.files in my user directory. I haven't been able to get the right format for --configure. It just gives me an unrecognized command error. Probably missing the obvious here, but any thoughts?

Thanks,
Ben KB0ZOM

1 - 2 of 2