Wait for a new release of fldigi that has the script fixed. kerry wrote on 2/15/19 10:09:

Download at www.w1hkj.com/files/fldigi/ : fldigi-4.1.01.tar.gz fldigi-4.1.01_i386.dmg fldigi-4.1.01_ppc.dmg

WOW. A lot of fixes. David Weiss From my cell phone.

Thank you in advance for any input on this. I am new to fldigi and I have successfully setup macros to control my FT-991A (Set band, freq, mode etc.) using fldigi macros, but one thing I can’t

Hi Dave, I have had a problem with your last two versions while xmiting compressed files via FLamp. I get about seven lines of data sent and then get a extended line length followed by a skipping of

Dave, I'm getting the same flamp problem. On a multi-file transmission with at least two passes, the second pass on the second file stops after a few lines. Happens on any op-mode, compressed or

Check the deadman timer Dave

I will test here running a multifile flamp transmission. Dave

There does seem to be something amiss here. On the first transmission of an 8PSK1200F file the headers were completely missed. The second transmission using 8PSK1000F skipped blocks as shown... <DATA

Good evening. I am new to fldigi this may just be a newbie thing. fldigi v4.1.00 Rig: Yaesu FT-991a OS: MAC OS X 10.13.6 Digi Mode: BPSK31 With the FT-991a mode set to DATA-LSB (or DATA-USB) the width

What radio are you using? Do you have any notch filtering set up???

Just had our first 1 hour interval without rain and thunderstorms in the past 48 hours. I tested flamp 2.2.04 and fldigi 4.1.01 with multiple file transfers. Both running on Linux Mint 18.3 /

I have an older plain FT-991… your answer is in the menus. You can select the data mode bandwidth there. If I was at my radio I could assist further but I’m not… The manual is your friend.

Thank you for the reply. Notch filter is OFF in the plain SSB modes (Non data) and is not an option when DATA-xSB is selected. What I don’t understand right now is that it started working … when I

Thanks for the response. I’ve read the manuals to no avail and thought that’s why I’d ask here for some help. Based on another response talking about notch filter I went and checked that which

I don’t the run rig control. I use the front congtrols on the radio, FT-920. Anyway, sound's like you have it "fixed", even if you really don't understand "what" did it! Onward and upward!

without knowing the rig personally I would say data mode automatically adds filtering to cut out the outsides of the band. You can work in the waterfall in data mode or see the full spectrum in

Hi there, The modem and sound card is internal to the FT-991A. Reading the manual they say that for data mode the rig must be in data mode. That said, I saw that I could transmit but I saw that on the

Might the rig have DSP set differently (e.g., Width & Shift) for different modes?

Hi This may not make much sense but maybe just entering and leaving the setup area and looking around, not even clicking anything and then saving again curred it. Just a thought. Marty kd8bj