Unfortunately I have learned that what I thought was a "clean" Raspberry Pi 3 actually had an older version of tqsl built, so without completely rebuilding a system I cannot come up with a 100%

Here here ... absolutely agree Harry. Part of the problem is also in naming ... tqsl, TrustedQSL are the references in all of the documentation. Nowhere do I read trustedqsl.

Wish ARRL would have put your tips into their build instructions. Thanks! 73, Harry W3YJ

I just went through this re-setting up my Pi 4 for ham use. It runs Raspbian, but since both Raspbian and Mint use APT for package management, this addendum will work just fine (once you

I just installed .5.7 on Mint 20 Cinnamon and it's working fine with CQRLOG. Here's how I install it: 1. Unpack the tarball to a directory in your homedirectory. Remember where! 2. Now find the tqsl

I have some basic installation details for TQSL in the HamPi playbook on GitHub: https://github.com/dslotter/HamPi/blob/master/tasks/install_tqsl.yml -- - Dave W3DJS

Thanks. I did it once and I did take some sketchy notes so it ought to be easier on the "clean" Pi 3. 73, Harary W3YJ

Send me an email if you get stuck. Dave On 11/19/20 4:15 PM, Harry Bloomberg, W3YJ wrote:

Dan, In the Pulse Audio Volume Control config page I have 3 lines, the first two refer to the built in audio. The third is labeled PCM2901 Audio Codec which is the sound card in the rig. It’s

I have a Raspberry Pi 3 that I have not installed TSQL on yet. I'm busy with a couple of things right now, I'll install TQSL from scratch and keep track of all the dependencies I must add over the

I am able to satisfy all of the TrustedQSL dependencies using either Synaptic or Aptitude. The process would be much simpler for a Linux tyro if there were build-dep scripts

Dave, I have a build process using Ansible that successfully builds TQSL on Linux. It's in the HamPi GitHub repository. 73, -- - Dave W3DJS

How about posting an Alpha to Omega build process for TrustedQSL on a Pi. Please include items like installing dev packages for OpenSSL and wxWidgets. David, W1HKJ

I did make same observation, Pi4, IC-7200, FLDigi 4.1.16.01. Does appear independently of modem used. Did not appear on 4.1.16. 73´s, Wolfgang

Dave - N9QNZ: One possibility is your setup could have Beaconing enabled. I am not familiar with the majority of your setup and therefore cannot suggest where to look for a Beaconing

Hi All, I'm not sure where to go for advice on this issue. I've been testing a relatively new setup with the following components: Raspberry Pi 4 MiniPro SC (audio

Sorry...should have added that you should ignore the top line (xrdp). I'm working on routing audio over a remote desktop session to the Raspberry Pi.

I think your recording tab should look like the attached.

hi Cliff - AE5ZA, well, i can't say all is working just yet but we did get rid of the roadblock - "Server String" texbox issue ! could you provide me with the setting on your RaspberryPi in the Pulse

Thanks! I will have to check out 2.5.7 later today. 73, Harry W3YJ