Re: Slop Bucket II Build So Far


 

New to me on this build is one of those heat resistant silicone pads available
on the Chinese sites.  There are little bins for holding parts.
The big thing for me is that it would slow down SMD parts as they flew/tumbled/rolled
off the PCB.

This isn't the one I have, but it's similar:
https://www.dx.com/p/jiafa-maintenance-platform-high-temperature-heat-resistant-repair-insulation-pad-silicone-mat-size-34-8cm-x-25cm-blue-2032504#.XF3llqB7lOQ




On 2/8/2019 12:11 PM, ajparent1/kb1gmx wrote:
#117 arrived a few hours ago.

Based on SB-I, I grabbed the fine solder, tweezers a a good light and
my soldering iron.  Its worked so many times before for SMT builds.

Oh don't forget the edged pan (I use a cookie pan) so the little critters
can't roll or slide away.  My glasses as well.

That and I'm about half way into it.  

Allison

Join kd1jvdesigns@groups.io to automatically receive all group messages.