Try it without the tuner plugged in. Radio direct to the dummy load. Carl AB1DD

#all

Somehow the long answer I made failed to make it. On the PA board there are thermistors that read the temp. I think that they are R734 and R736 The hottest is directed to the CPU via D705 as the THML

#all

Bonjour, Mes liens sont les suivants: Radio->SWR->tuner->antenne 73 de F6FSC Michel

#all

Hi Carl, My links are as follows; Radio -> antenna tuner -> SWR/PWR meter -> Antenna Nothing else plugged into the tuner. --- Thanks & 73's de VK6KC Kurt Baeten

#all

Thanks Dale, in my case the tuner doesn't seem to make much SWR difference between antenna connected via tuner or direct. I also had RF and also used toroids and ferrites and seemed to fixed that prob

#all

Do you have anything plugged into the rear antenna tuner port? Some devices that are not designed for the 7000 will cause the temp to read high, even though they will work with other Icom radios just

#all

You may have a bad thermistor and that goes to the CPU and that will fold the power back as a function of the ALC and the CPU is what creates the indication on the screen. There are two NTC resistors

#all

I always run two 12volt computer fans behind the 7K particularly on FT8 but I run no more than 50watts output into an inverted vee fan dipole so similar conditions just lower power. I found it wasn't

#all

I bought a 7K (after having been out of the hobby for 30 years) and it’s a great little radio BUT the temp gauge always shows HOT, even after just switching on. also the fan always runs, even after ju

#all

I bought a 7K (after having been out of the hobby for 30 years) and it’s a great little radio BUT the temp gauge always shows HOT, even after just switching on. also the fan always runs, even after ju

#all

I seen some people were looking for the remote head cable Rich W6ABJ https://www.facebook.com/groups/HamRadioForSale/permalink/1966424013495414/?sale_post_id=1966424013495414

https://www.ebay.co.uk/itm/284102959284 This is an alternative also. Hope you are successful. 73 Tom M0RMY

that's interesting, I do have a 3D printer .

Hi These are very rare. I have a permanent search on eBay set up for them. As said previously they do occasionally come up for sake at about £70-80 minimum. I did a bit of a search and found this: htt

The cables show up on eBay every so often. You can setup a search on eBay with the correct search terms and SAVE it. Choose to be notified by email and text. You might need to be patient; it could tak

Dimitrii, DM5AL, still offered these kits on a limited basis. I bought mine this fall after getting on his reservation list. Not sure if he still does. https://dm5al.de/index.php Doug N2BEG

ICOM IC-7000-HDMI MANUAL Pdf Download | ManualsLib 73’s - Glenn

One could make the cable----If one could find connectors. There is a German company that makes cables based on a special HDMI cable and connectors. Sometimes they are listed on eBay. I currently don't

I’m looking for one too. I wonder if it’s possible to connect to the pcb

"Is it possible to make your own head separation cable? Are the connectors available? A check on the internet shows these cables to be pretty much extinct." Larrie AF7NU Great question Larrie. In all