I built my cable and ran it to my AvMaps G4T, Works great.. FYI: Due to the same problem that most of us have (MONEY) I'm looking at selling my station. I have the IC-7K with remote mounting

Thanks Jimmy, my bad. Ryan Davis r a t i o 801.309.3055

Regarding the static bleeder resistors, the 7K's HF port has 3 33K SMT resistors in series (to increase breakdown voltage) to ground near the J1 HF receptacle. They are on the bottom of the PA board

IC-7000All: I am interested in seeing if the IC-7000 can be remotely turned on and off (as part of remote-controlling the entire radio over the Internet). I've done a brief pass through the manual,

I believe there is a 3.5 mm jack on the back of the 7000 for video output. Pages 11 and 18 in my manual. I don't recall any output from the ACC socket where the Din cable plugs in. Are any of these

The video out on the 7000 is on tine back it is as 1/8 in jack not the din jack. Jimmy (WB8NBI) Sent: Monday, February 15, 2010 8:52 AM To: ic7000@... Subject: Re: [IC-7000] Remote

Gene, If you have factory nav you have to first buy an adapter that will allow you to put aux video signals into it. For most of the GM products it's about a $300 part. Some are less but by now there

Hi All- I just bought a seven inch Eviant portable digital TV with AV input. Now I have the nice radio display and a TV in my shack. TV was on sale at Sears for 79.99 and all I had to get extra was an

Gene,   Take a look at this link.  I plan on getting the system for GM to place in my Tahoe to do the same as you are looking for.  It's a bit pricy, but will do what you

I wish I could offer some firsthand experience. I do know that one of our club members has his 7K setup in this fashion in his car. The video out is fed to the nav system in the center console and the

I have a color brochure from Icom showing the IC-7000. On the front cover it shows a right hand drive auto with the display showing on the center console of the auto. I have a similar video console on

Hi Group Thanks for the input. I took the spectrum analyzer/tracking generator out to the car and measured the path loss between the two antennas. This involved disconnecting the two down lines and

For 2 and 70cm the Diamond V2000 and for de shortwave a ofc wire dipool, 80 meters long. See te pictures

The only place I look at equipment is qth.com You will find some great deals, a good feed back forum to check out the seller / buyer. I bought my 7K on there for $900. 73- W1JCW John Sent:

The Icom AH-4 antenna coupler. Press and play tuning. - Jeff/wb0m

--- <billwemail@...> wrote: I bought mine "reconditioned" in Jan 2007 from HamAv Electronics @ $1100. http://hamav.com/ They were great the deal with and at the time the price was about the same maybe

I got mine at Dayton in 2007. Total shipped to my door was $1269.98 including RMK and LDG AT-7000. It made the radio about $1100. Les, K8LES

I still have no idea what happened but the stars must have aligned when I bought mine. I'd been stewing over the decision to buy for about three weeks and finally decided it was go time- this was back

I have two IC7K's. One I use mobile with a Tarheel Screwdriver model 200 and an ALS-500 mobile amp. The other I use in my fifth wheel RV with an Eagle-One push-up antenna and an Icom AH-4 tuner

I'm ready to buy an ICOM IC-7000 Been trying on EBay but not having any luck. I may just wait till the Dayton hamfest. They may knock a few hundred off What are you guys using for a base