Hi also it looks like there is no heat sink compound on the pa driver board , I see this is very common ,as on TRX bench YouTube channel,so I may as well do this while I am in the radio, I have also

Hi John I am going to test for any resistance on the remote socket, what is the best way to get to the solder points of this socket, do I remove the top board, or is it from the bottom side of the

Hi John you are thinking the same as me, yes I used contact cleaner on the plug, The civ works with ham radio deluxe, but I will open the radio and look if it is showing as a short, Like you said

With power off, remove the covers and with a multimeter check to make sure the PCB lands associated with that jack are actually shorted. I have seen dirty/contaminated/corroded jacks. Have also seen

Hi Paul Yes I have been holding those buttons down when switching on , as in the service manual, Thanks Dave, all help is appreciated,

Not only does CI-V have to beshorted, you have to hold down the Pre Amp and Tuner buttons simultaneouslywith turning it on. The 7000 is a difficult radio to work on in the adjustmentmode so good

I guess that if there is something amiss in the initial programming of the radio then resetting it will not rectify the problem. Hoffy

I have done a full reset, Dave

Yes that's what I am thinking, Thanks Dave

Sorry Dave, I hope that somebody has the right answer for you. I wonder if there is some sort of programming /software glitch in the radio. Once again I wish you all the best.

Hi Yes yes it is A 3.5mm mono jack plug ,so only 2 pins to short, I have used this plug for cat control, with this radio and ham radio deluxe, So I don't know why it will not go into adjustment

Hi Dave, Hoffy here, just double checking that the 1/8th plug that you are using has been "shorted" as per the instruction of the manual. Cheers and all the best, Hoffy - VK4OY

i can not get my radio in to adjustment mode, am i doing something wrong, i have a uk (10) model , i am doing as page 16 of the service manual says,and the radio just starts up as normal, my civ port

Good day Peter. You are here! Hopefully, some of the group can help with your 7000 issue. All the best, Russ KW6T California

Please Can I be considered for membership of the group. As I own an IC7000 that is giving me trouble My Call sign Is VK6YV Peter Savage 6 Stadia Court Beldon 6027 Western Australia

IC-7000-HDMI Separtation Kit DM5AI Manual attached. I have used it for a year. Jim WI6X

Hi Larry, Those are in short supply. Neither is available from Icom any longer I do not believe. DM5AL has a separation kit he designed. I am not sure if they are still available or not. You would

I picked up a second IC7000 at the hamfest.. Rig is 9.5 of 10.. It came from an estate, and there was no box, no separation cable- control head mounting. There was a 706markII and it had the

I think I wrote something on this long enough ago that I have forgotten most of it. Do a search and see. I worked on the ALC extensively at one time, but I forget the specifics.

Thanks Steve, I was already using your measurements from your past post to troubleshoot this units operation. At R1624 and Q1606, Im getting about 2.5 volts no ptt, and 1.4 with ptt, both being