That is normal with the scope scanning

I would say your dah problem is the bandscope. Change the lower part of the display off the bandscope on to another option it will go away. This is the slow processing process in the 7k. The bandscope

There is a pulsating sound associated with the scope, especially when the sweep speed is high. I think there is a menu item to decrease this sound. VY 73 de W3UEC Steve Dubin A clear conscience is

J.D. Thanks for the question. I tried both attached and not--no difference. This is my first experience with the 7000, so please bear with me. I reset the radio, and the noise disappeared.

Does it do this without an antenna attached?

Hello all. This is Russ Williams, KW6T. I was first licensed in 1985 and have been active since 2003. I am in Latrobe, California about 15 miles from the current "Caldor" forest fire. The smoke is

Thanks everyone for the input. (had to do my real job for a few days, so will be back to work on it now.) To be clear on my setup: I’m using DIN 6 for audio, rx and tx, but using CAT for tx rx.

No Data mode on the IC7000 Audio on the 13 pin is summed with the two mic inputs so if using that connector you will want to unplug the mic(s) PTT on the miniDIN6 will mute both mics and the 13 pin

With connections to both the DATA (13-pin) and 6-pin DIN jack: . . . Is it possible that the IC-7000 is getting a PTT signal on the 6-pin DIN jack, . . . . and audio on the 13-pin DATA jack, . . . and

Bill, Mine is simply in USB mode - with the interface connected to port in the rear of the rig. 73's Glenn

Do you have to put the radio into usb-d mode?, or am I confusing this with the 746 pro? Would you believe? Sent from my shoe phone's big brother and still no keyboard. Please excuse auto connections

Thanks Carl…. more questions / advice (before you tear the rig apart) have you ever been able to work digital modes with your 7K (or any rig)? do you have anything other than the Unitek

JD - going in through DATA connector, 6 pin DIN, and separate CAT cable. I’m trying to get one of the AX.25 programs working, so I can try on FM, which will be a different modulator. Glenn - yeah I

CB – before you rip the rig apart… does your configuration support other digital modes (i.e. PSK, FT-8, Olivia, etc)? Are you using any sort of commercial interface between the computer and your

What connector are you feeding the audio into? The book says that the front mike is disconnected win digital. Perhaps the audio signals are not going into the proper pins? Does it work on WSJT-X? 1

Thanks for the response. I’m using CAT control and everything there works. In fact, I can hit TUNE on JS8CALL, radio goes into transmit, and will modulate my voice from the speaker mic. It’s

The problem is probably that your software isn't telling the IC-7000 to go into XMIT mode. Check the settings in JS8CALL, see how it is doing XMIT / RCV switching, and check that whatever it does on

Hi Team I have an IC-7000, transmits well with hand mic both FM and SSB. Transmits Tune tone well. When using JS8CALL, audio is not getting onto the signal, I see no power fluctuation on the

Yes, the ML920S/DN works fine. It has the same surface mount tabs as the /F9D. The only difference is the coin cell has an insulating wrap around it, which is fine. The price at digikey.com is

I believe it is in the silver logic unit, left rear top of the radio. From bad memory.