Nope...it keeps going back to 10.753 hi.

Thanks Chuck...I'll do that. Probably put it in CW portion of 75 and leave the original on the high end for SSB. 73, Bill

I can't answer your question, but it's along the lines of a problem I have. My IC-7000 is primarily for 2m and 70cm, but it's my backup rig for HF-6 also. The problem is that I use it so

Bill: Select the band you want to move while in VFO mode. Press TS to select fast dial then spin to the frequency where you want this extra "band". Press TS to go back to normal dial speed. Now press

I actually like the idea....just not between 30 and 20...

Hi Chuck, Yes that's it. It looks like I added "General" to the band up and down. I thought it was 30 meters but I think I was on 30 at the time. OK so how to I erase that hi? Bill

Bill: I used an IC-7000 in my truck for quite some time before having to retire it to my shack, so you'd think I would just know this. I'm pretty sure though that the 7000 will

Somehow in all my switching this past week chasing the VP8, between CW SSB and FT/8, I accidentally added an extra 30 meter screen to the "Band" up and down. That would be OK except when I try to

Got it figured out - thanks anyway! Paula

I am trying to set up N1MM to run RTTY using the MTTY digital engine. I am using a Signalink Interface. Do I keep the rig in USB mode like I do for other digital programs, such as HRD for PSK31?

Dear All, These are some ICs taken from other parts damaged logical unit of icom ic7000,parts are available in 2 qty of each ,This will be replacement for DSP ics damaged in the logical unit

Guess they're gone... W2CQ

I have a few surplus flat cables on Ebay Item 153810076642 In case you need them. OE8UWW

Hi, All, I'm still looking for a nice MFJ-706 or MFJ-7000 here in the UK (overseas deals would probably not be effective because of the weight). I wrote the original review in PW and was talked into

Thanks. One more thing to try; I was thinking of hanging headset on the cable to hear whether there are any signals coming through the cable,too. Take care rom

You could connect the 7000's video o/p using a switch to the reversing camera input to the vehicle display. The switch would also put a 'dummy' reverse signal to the display unit. I did this for my

Don't forget about video out on the back if you are using the 7000 as a base unit. Any video monitor or display will work. Bob Hi Ron I’m looking for a new control panel 😊 to buy My

Don't forget about video out on the back if you are using the 7000 as a base unit. Bob

If you are indeed using the CI-V port on he radio, you should probably go into the menu and UNLINK USB FROM REMOTE. Your now have two separate line of communication with the radio, using the USB as

I have a USED IC-7000, I know the display is fine and this radio may work, it does receive on all bands and acts like it wants to work. This is a radio ONLY, no mic, no power cable or mounting