I use my IC-7000 as my base and occasional mobile. The only transmit audio problems I’m aware of are caused by the stock HM-151 mic. I used to have a fairly elaborate desk mic/equalizer setup to

Hi everyone. I am considering buying an Icom IC7000 for mobile use and have been reading about the reports of poor tx audio. Can anyone tell me if this problem has been overcome by Icom? I have had

Hi, The main board of IC7000/driver board was sold , PA unit ,DDS unit, CPU(working perfectly checked) ,case ,ribbon cables,cooling fan interested people can contact me ,you can use as spares for

Thank you for the replies much appreciated. If I were wire the audio to go in through the ACC socket , would I be best to wire a PTT through the modular Jack?

That's my experience. For SSB once you have the basic settings correctly configured one isn't going to make a material improvement by changing microphones, adding an EQ, signal processing, etc.

Hi, The main board of IC7000 was sold ,any way PA unit ,DDS unit available, interested people can contact me ,you can use for spares or donor for other icom ic7000 radios ,the above units were taken

I have been around a long time and what I notice is that many HF operators take little care to insure they are not splattering their audio all up and down the band. You do not need very much

FWIW -- I haven't played with the IC-7000, but I _have_ played with my Yaesu FT-450, using both a Shure SM58 dynamic mic, and a Behringer C-2 small-diaphragm condenser. I ran the C-2 through a

Studio mic freqency response 5 Hz to 30000 Hz IC7000 mic from 100 Hz to 3000 Hz :-) w.

Hello All , Is there anyone here that experiments with their audio with a studio mic , pre amp , eq etc, ? I would like to know what you use . Thanks , es 73 VA3GRV Vince

HI, I have one icom ic7000, main board available for sale, all components are intact, price 200usd, payment by PayPal, interested can contact me for more info , 73s

Ah Helmut....well no you didn't miss it as I discovered the answer, and as no reply was posted I decided to remove the post rather than bother the forum with what turned out to be my lack of properly

The solution, did I miss it? OE8UWW

Sorry, tried to delete this post as I found the solution. Somehow I succeeded in reposting it. .

Joe: So far so good. I'm still getting used to some of the differences between the radios, but for the most part the controls make sense. The cool thing about it is that the

Hello , I just thought I would add a simular question regarding PTT. If I were add a different mic and preamp to pins 11 and 2 on the ACC Jack, can I make a PTT for use through one of the modular

I'm after some clues on a video issue. I have a friend's 7000 that he can not get the video to work on his dash monitor. I connected it to my external monitor which works fine with my 7000, I get a

Tnx Chuck, I'll take a look at that. How do you like the 7100??

Joe: A long shot, but possible. There's been problems with the Logic Unit that causes a variety of problems. That's the metal-enclosed unit under the back-left of the top cover. I don't have

TNX All I will give that a try. I did the reset but that did nothing..