Hello there, I got the same problem with you my friend. I have bought the ZLP CI-V interface and even that I'm testing it with it's self tool that certifies it is up and running at port-x the HRD is

Hi all, Despite all efforts I can not get my HRD to connect with my Ic7000. It has before sometime ago. Ok Cvi is off on rig address 70h, 300 baud on both rig and software.Tried Rts etc ticked and

What type of computer are you using? I have experienced the same problem on my Mac and IC-7410 with the same programs. I just got the SignaLink to try to remedy it. I can get 2 clean TXs before it

Thanks, Bud, but unfortunately it's not that simple. No problem with missing from macro, and no way to toggle back to receive with either fldigi or flrig. The 7000 TX light stays on. Bart/kh7c

Are you sure that you have put <RX> at the end of the message? You should be able to toggle manually from TX to RX to make the red light go off on the Signalink and radio to unkey. Bud KC5IAJ

Hi Everybody; While I was giving my presentation during the TAPR show last fall in Chicago it was recorded byGary Pierce (KN4AQ). He just has released the talk now on YouTube. As a materof fact Ham

I am having two, possibly related problems with my IC-7000, connected to fldigi/flrig through a Signallink using the 6 pin cable and a CI-V cable with a good chip. The problems are new, and I can't

The issue here is not about one computer talking to multiple radios via a serial port. The user wants to have a tuner controller and a computer talk to the same radio over one CI-V port on the 7K.

Look at N4PY software. I believe it will do what you want. Steve K4ELI

I think the OP was meaning remote operation via internet/IP many 100's and even 1000's of Km's. The clue is in the phrase "Take it along with you" 73, Graham - loving my 7000 more each day!

Hi the icon 7000 has a remote wired connection system which works fine. having used it in a 4x4 for the last 6 years. with the advantage the microphone can also be used in the head unit. however i

Hi so why should it not work a Ci-v port has different addresses for each device so it can communicate to each as an individual unit. you

CI-V is a “one wire plus ground” simplex serial protocol using open collector/drain transmitter devices. They can be wire-ORed with no problem unlike normal RS-232/TTL level duplex

I don't plan to share a computer's serial port, so not sure it's an issue, but I'll report if and when I do this. The unofficial IC-7000 faq that I found says this should work. we'll see. 73

The IC-7000 has 2 separation cables available an 11' and a 16'. The OPC-1444 is the 16 foot cable. Works well for me.

The old 706 and newer 7100 can Do it The 7K has a video signal for the display and it cant se separated as remote without the cable But with over CAT with a good software in the other end ... It will

http://www.remoterig.com/wp/?page_id=452 Looks like it might work. The other Icom rigs are similar. 73 de W5ALX EM85ro Buncombe County NC Alex Netherton http://blueridgediscovery.org

Yeah! Push the button on the right side and slide it to the left. You do have the separation cable, right? Mike W3LNA

Is there a way to remove the front face of the IC7000 and take it along for remote operation like the TS-480 radio can do ? How is anyone using their IC7000 remotely ? Programs ? interface ? etc