Re: Repair IC-7000 parts


James Fisher
 

OK thanks James
On Saturday, August 24, 2019, 7:22:20 AM MDT, J.D. Barron <jeter.d.barron@...> wrote:


To access the power plug you have to unsolder the driver board, rf connectors etc, but it is not all that bad of a job.
On my IC7000 the problem was really with the plastic body and the pins were OK.
I had to get under the board for other repairs, but while there I did replace the plug body.
Basically I don't pull the plug that much as I use Anderson Power Poles extensively.
Basically it is not that hard to replace the speaker jack either, but first I would make sure that you are using a true 3.5 mm plug and not a 1/8" as they are smaller and often don't make good connection.
Before I sent it off I would make sure that I had a very good 3.5 mm plug and see how that works for you.

Join ic7000@groups.io to automatically receive all group messages.