Re: Ic 7000 problem
James F. Boehner, MD
toggle quoted messageShow quoted text
Yes. The power supply is staying at 13.5 volts, but strip each wire a bit between the fuses and the radio and measure the voltage there when you transmit.
When the fuse holder was the culprit, sometimes removing and reinserting the fuses several times temporarily fixed the problem..
’73 de JIM N2ZZ
From: email@example.com [mailto:firstname.lastname@example.org] On Behalf Of Chris
Sent: Sunday, March 25, 2018 1:21 AM
Subject: Re: [ic7000] Ic 7000 problem
Jim on the fuse you are talking about the fuse on the power cable. Right
On Sat, Mar 24, 2018 at 8:43 PM -0700, "James F Boehner, MD via Groups.Io" <jboehner01=yahoo.com@groupsio> wrote:
This is redundant to the last post, but the IC-7000’s had a major problem with the supplied fuse connectors and fuses. Even if not visibly corroded, this resulted in a major voltage drop, and caused the radio to behave like you describe. The 7000’s are very finicky on voltage. Before you send it off for repair, it would serve you well to remove the fuse holders from the circuit entirely. I have done so, and I connect the radio with power poles to a power pole strip that is fused.
I don’t remember the current requirement for the radio on transmit, but have at least a 20 Amp 12 VDC supply.
’73 de JIM N2ZZ
Yep check that I just can’t find a reason for it. At fist I thought RF was the caused. But that turned out not the cause. It’s only when you key the mike it shuts down and restarts.
On Sat, Mar 24, 2018 at 8:03 PM -0700, "Alex Netherton" <w5alx-groups@...> wrote:
Make absolutely sure the fuses are not corroded and there is no voltage drop at the rig. When you key, check that the voltage does not drop too much, or the rig will shut down.
HTTP:// blue ridge discovery.org
On March 24, 2018 at 10:39:31 PM, Chris (wb8ypo@frontiercom) wrote: