Re: [IC-7000] How do I stop feedback through the Speaker
|
N1GBE
You may have the monitor function enabled... The monitor function allows you to monitor your transmitted
signals in any mode through the speaker. The CW side tone functions regardless
of the monitor function setting.
1. Push [AF(set)] momentarily
to enter the Set mode menu.
2. Push [F-4 OTH] to enter the miscellaneous (others) Set
mode.
3. Push [F-1 ≤] several times to select “Monitor.”
4. Rotate [DIAL] to turn the monitor
function ON.
• Hold down [F-4 DEF] for 1 second to return to default condition.
5. Push [F-2 ≥] to select “Monitor
Level.”
6. Rotate [DIAL] to adjust the monitor
level.
• Hold down [F-4 DEF] for 1 second to return to default level.
7.
Push [Z(menu/grp)] twice to return to normal operating mode.
Use
headphones to prevent feedback.
Regards, N1GBE
From: "kdbrady1963@..." To: ic7000@... Sent: Thursday, January 23, 2014 4:50 PM Subject: [IC-7000] How do I stop feedback through the Speaker I'm still working on my mobile installation. I have a 102" whip attached to an Alpha MOTO Sr. The whip is standing upright. I am using the separation cable. Therefore, I have the control head mounted at the top of my windshield, with the main unit in the rear of my mini van. I have the Icom SP-35 mounted on the dash, off-center, on the passengers side. I have this antenna going through an LDG AT 200PRO II tuner. When I went to transmit, I could hear myself through the speaker. I even unplugged the external speaker with the same results. When I checked my output, I found that it was nill. Although, I know that I did get out, as someone did catch part of my call sign. What did I do wrong? If I didn't do any thing wrong, what can I do to correct this problem?
Thanks - Keith KB0CAP
|
|
|