Topics

Clicking on spots always SSB

Ignacy Misztal
 

Clicking on spots always reverts to  SSB mode. 
BandMode selection is set to "Mode from radio or DX spots". Setting to "Mode from BandPlan" does not change anything.
Radio is Flex 6600 running 3.1.18.
Ignacy, NO9E

Bob
 

Does 3.1.18 refer to some version of Flex Radio software, or Logger32 version? 73.

On November 30, 2019 at 9:46 AM Ignacy Misztal <no9e@...> wrote:

Clicking on spots always reverts to  SSB mode. 
BandMode selection is set to "Mode from radio or DX spots". Setting to "Mode from BandPlan" does not change anything.
Radio is Flex 6600 running 3.1.18.
Ignacy, NO9E

 

Ignacy Misztal
 

3.1.18 is Flex version. Running the newest version of L32.
This setup is for a remote station. At home with K3, L32 is working perfectly.
Ignacy, NO9E

Bob
 

Try setting Mode from BandPlan with the other two mode from options unchecked. Then, when you click on a CW DX Spot. if the radio does not switch to CW, then look at your personalized band plan (click TOOLS the SETUP BANDS & MODES) match the frequency in the 3rd/4th columns to the DX Spot frequency ... Does the 6th column say CW? If it does say CW, then the radio should have been commanded to switch to CW. Now you'll need to open the Radio debug Window (right click on the radio pane - at the middle of the lower status bar - then click SHOW RADIO DEBUG WINDOW) and examine the commands sent to the radio. 73.

On November 30, 2019 at 9:46 AM Ignacy Misztal <no9e@...> wrote:

Clicking on spots always reverts to  SSB mode. 
BandMode selection is set to "Mode from radio or DX spots". Setting to "Mode from BandPlan" does not change anything.
Radio is Flex 6600 running 3.1.18.
Ignacy, NO9E

 

Ignacy Misztal
 

MODE from BandPlan still retruns SSB. 6th column in Bandplan says CW. The debug windows shows:
QSY Market Set: Radio Freq. 7019.9 QSY Marker 7019.900
Set RX1 Mode: ZZMD00;
Set VFO-A Freq: ZZFA00007019900

Bob
 

Yes,  Set RX1 Mode: ZZMD00; will set the radio to LSB as expected. Flex Radio has no CW mode. Try CWL and/or CWU in the 6th column. SeventyThree(s). 

On November 30, 2019 at 6:24 PM Ignacy Misztal <no9e@...> wrote:

MODE from BandPlan still retruns SSB. 6th column in Bandplan says CW. The debug windows shows:
QSY Market Set: Radio Freq. 7019.9 QSY Marker 7019.900
Set RX1 Mode: ZZMD00;
Set VFO-A Freq: ZZFA00007019900

 

Ignacy Misztal
 

Now it is working.
Getting Flex to work fully is a full-time job!
Ignacy, NO9E