Rick Williams wrote: Another small point, you do NOT have to be connected to utilize the "packet window". 73 Ed

Thanks for the reply. To clarify however, there's a small "DX Cluster" window (upper right) and then the "Packet Cluster" window. If I sit down in the shack, turn on the 2m rig & tnc and then

Steve Logger will allow you to use the "DX Cluster" window to click and QSY BUT that window only receives data for DX spots that occur AFTER you have connected. So a Show/DX won't be of much help in

Yes, you definitely do not have to be connected to get spots in the small window. Am trying to get Bob to extend the filter capability to the Cluster window also. Remember, any filters you set for

Rick Williams wrote: Perhaps something to ease your minds in this particular case. The packet code is set to look at the next spot which appears and see if it is substantially equal to the last

Hi Everyone. Glad I found this list, as th old Logger List was apparently deleted without notice! -- Cul8r Martin Campbell rutherford.ulea@... KB0HAE Want to help stop

Welcome! Yes, the list manager for the old list just decided he had enough and pulled the plug. He expressed that none of the old archives or anything be revived or associated with him. He may

Hi Fred, Thanks for picking things up. Bob, K4CY, responded to an email of mine regarding importing LogWindows to Logger and told me of the group's move. He said someone here might know the

I am trying to get my new 746 to read the frequency and band. I keep getting the message "Radio Port: Transmit Buffer Full". Doesn't work at all though it seems like it is trying. Please

Perhaps LP1ZO, I believe that's his call will jump in, also you can try http://ve9dx.weblink.nbtel.net/ and see if anything there will help you. There are lots of conversions among the

Hi All, I am attempting to find copies of older versions (any other than 7.3) of Logger. If anyone has them could you e-mail them to me directly, or point me in the direction of where they can be

thanks for the quick reply Fred. Danny

Hi, Usually there is problem that "Transceive" mode is set to ON in tcvr setup. Check it and give "Transceive OFF". I'm using IC-746 without any problems. 73 Josef OK2WO

I have just purchased a new Pegasus from Ten Tec. I have installed some programs and am looking to find what would work well with the Pegasus. The programs I am looking at are Logger, ACLog1.5 and

Only one way I know: Use Telnet (in Logger) <> IZ4AFW Interface (SW - www.qsl.net/iz4afw) <> SV2AGW (SW TNC - www.qsl.net/ok2wo). It works for DX Cluster Monitoring/Connection (no file transfer is

Dear Members Is there any chance to use Logger together with Flexnet? In other words with a software TNC! Thanks for your responce in advance! Best regards Raffaele HB9UAG

: Could you explain what these are? I went to both of these pages and wasted 30 minutes and have no idea what they are talking about. This is not because I am not technical, it is because the pages

N4IXL wrote: Sri Fred, these pages are not for education. It is simply crossover or source of files/programs which you can use. You must download it, unzip and read README and HELP files if you are

keep work I did some error and message was not sent. Again: Jiri OK2WY focused me to MOST IMPORTANT thing: If you have got this message your interface is not powered. If it is powered from Com

Dear Josef I will come back next week with more details. You are correct, these software types are replacing the hardware TNC. Then only thing which is necessary is a simple modem (Baycom connected