Hello, I am using logger32 for my logging purposes, and i use WSJT-X for FT8. Now here comes the tricky part. Running either JT-Alert or Grid Tracker, stops the auto log from WSJT-X to Logger32. What

What mode does the 7610 use for CW operation, CW or CWl/CWU? Make sure you have the correct mode in your bandplan. Jim K4JAF

On 06/13/2021 3:50 AM Rob <g4ujs@...> wrote: > 4.0.266 has a new menu to set the digital rotator direction window to be on-top Can't find this, where is it? 73 Rob

I have the same question 73 Jan PA4JJ Op 13-6-2021 om 09:50 schreef Rob: -- ____________________________________________________my dxspider

Hi Bob Seems to have fixed the issue I was seeing of the QSL info going missing. Many thanks 73 Pete G4RRM

>4.0.266 has a new menu to set the digital rotator direction window to be on-top Can't find this, where is it? 73 Rob G4UJS

I had you , and several others, in mind when I added that. Let me know in a few days it that has resolved your problem. SeventyThree(s).

Is this something new, or has this behavior started since you figured out why your Flex radio didn't work? When clicking on the CW DX Spot, did Logger32 send a command to change

David, one possible reason could be the entries in your Band / Mode Table. Look at what you have entered for "Radio Mode" for your CW entries for each band; -- 73, John - G7SSE

Now that the Flex is working, I note that the 7610 responds to a CW cluster spot by a frequency change but does not keep the correct mode. It changes to SSB. I don't see an obvious menu setting in

NEW BEHAVIOR IN v266 I downloaded .266 and in this version I get a popup notification to turn off the cherry picker to run the sync. This may have been the culprit.

The file is pretty small - maybe three to ten QSO's. After a few QSO's that have been auto uploaded to LOTW: (1) I manually click the "Download LOTW QSL Information and sync into Logger32" button on

They may have been warned but - - - - will they listen? Again thank you for all your hard work, Larry K8YYY -- I got expelled from school on

Today's auto-update of v4.0.266 has a new menu option to recalculate statistics and at the same time recalculate distance based on gridsquare of the QSO. For those who have a logbook

v4.0.266 has a new menu to set the digital rotator direction window to be on-top. There is an additional recalculate stats menu that will also recalculate distance (if the QSO has a gridsquare

Thank you. I have read and re-read all notes from Bob, Ted and Jim. I found a way and needed to add a virtual serial port for Logger32 in CAT after the software change (COM19) and the frequency now

As another suggestion, have you placed a trouble ticket into Flex support. They can walk you through your problem and will reply to you very quickly during the week. Do this, instead of struggling

There is outlined on the Flex Radio Community site a method to remove unused CAT ports created by the SmartSDR software. This will free these ports for use again if not currently assigned. This may

David, Are the Flex radio and SmartSDR both on version 3.2.39? What com ports are defined in SmartSDR CAT? You should also see these ports in Device Manager. SmartSDR CAT is where the virtual

... at what stage of the process? With what options selected? Just a little information to point me in the right direction would be helpful. You said - ... but hangs on subsequent attempts. How often