Re: DX Spot No QSY Radio.


G4GIR
 

Cheers Bob, I think it makes sense to have that capability.
 
73
 
Ian
 

----- Original Message -----
From: Bob <k4cy@...>
Sent: 13/10/2021 18:07:34
Subject: Re: [hamlogger] DX Spot No QSY Radio.

I have made changes for the next auto-update so that clicking on an FT4/8 DX Spot on a different band/mode sends commands to the JTDX control panel to change band/mode. 73.
On 10/12/2021 3:03 PM G4GIR via groups.io <i.frith@...> wrote:
So things are all good?
73
Ian
----- Original Message -----
From: Bob < k4cy@...>
Reply-To: < hamlogger@groups.io>
Sent: 12/10/2021 19:51:04
Subject: Re: [hamlogger] DX Spot No QSY Radio.

When operating with JTDX, look at the radio pane of the Logger32 lower status bar. You will see that the Logger32 radio port is closed. SeventyThree(s).
On 10/12/2021 2:27 PM G4GIR via groups.io <i.frith@...> wrote:
Hello All

I have a setup using JTDX, L32 and TS990.

If I click on a Band in the JTDX Control panel, the Radio QSY's, JTDX QSY's and L32 logging window QSY's.
If I click on a Frequency in JTDX the Radio QSY's, JTDX QSY's and L32 logging window QSY's.

However
If I click on a DX spot  L32 Logging window populates with the Call and  QRG, the radio doesn't QSY and JTDX doesn't QSY. Is this correct? Tried to find an answer in the manual but no luck.

Clicking on DX Spots when just using the Radio and L32 works OK. Radio QSY's and L32 Logging widow is populated with call and QRG.

Any ideas please.

73

Ian G4GIR

Join hamlogger@groups.io to automatically receive all group messages.