I have recently purchased the Felder RL-160 and need to buy a compressor for the automatic filter cleaning. Can anyone recommend what to buy for this? I am not too familiar with compressors and the co

Hi to all who have Phase Perfect converters. Today we just finished installing a whole house backup generator (Lots of rolling blackouts, wildfire safety shutdowns etc. here in northern CA) It's a Cum

I have a Laguna 24/24 Bandsaw that I use for resawing and most often, ripping. It has the Co-Matic pneumatic feeder. My problem is that the max distance between blade and feeder is around 5.5 inches.

hi all I have been using my K500 pretty frequently enough the last few months to learn what I like and what needs improvement. I bought David Best's guide which has proved really useful even for the K

I purchased a Felder RL-125 dust collector in 2010, and have just got around to setting it up and using it (I was too optimistic in thinking I would have a lot of time on my hands to engage in a hobby

Hi all, The crosscut fence of my K500 has a small plastic plate with a grub screw which clamps the scale down into the aluminium channel. This plastic plate/clamp has broken (probably due to over-torq

Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hey guys Finally got the shop construction done and I’m ready to place an order for a slider. Prices have really climbed! At any rate, I’ve read many threads on this topic and took prior recommendatio

As previously mentioned, the thicknesser lever on my C3-31 has all but seized up. One technician was very helpful, talked me through things and sent me a couple of very helpful drawings. TBH I’m still

Seeking opinions on how YOU would make this handrail. Sample drawing attached, matching an existing millwork package from circa 1900. Starting stock will be approx 5"x5" glued up sections OR 2 halves

I noticed today a new problem with thicknessing on my 2006 AD951. Across the 20" width of the table, there is a discrepancy of 0.6mm and that was measured after inserting new Tersa blades. Both table

I likely order one tomorrow but thought might as well ask if you have one and how you like it. Imran

I just bought a used K500 and it didn't come with a rear crosscut fence or the mounting hardware to install it. Should I buy new from Felder, or is this something I might purchased used from one of th

Hi all Dovetailed serving tray for the wife, so a compound butt joint is what I need, and I can't figure out how. I found the video on compound miter joints from the Extreme Woodworker: https://www.yo

I turned on my D951 with Digidrive last week, and it showed a ENCO error, which translates to an encoder error. I called up Felder tech support, and was told that the motor needed to be replaced. Well

I have access to a Milwaukee mag drill (see attached) for a limited time. Heavy! Great for tapping holes on a cast iron top such as a shaper for being able to bolt on a sliding table. However, I was t

I need to order my first replacement Tersa knives for Dual51. l see HSS and M+ with little diff in price. Any recommendations between the two? Per the website HSS is fine for common hardwoods that I i

I picked up the used hammer b3 (and a3-31) listed here in early April. I’m transitioning from a cabinet saw so I’m just learning how old techniques map to this style of machine. I’m curious if anyone

Hello all, I'm new to the group and Felder machinery. I run a full-time shop which has a mixture of SCM, early 1900s Oliver, Walker Turner, Sawstop, Grizzly, etc. I realise this is a lot and am thankf

I was making a 30 inch wide refrigerator panel this evening. I allowed a bit extra for squaring. I placed a long edge against the saw fence, cut a bit off one end, flipped the board, and cut a bit off