Re: D4D not working

Adam Rong


The diode mod suggested by KD1JV can increase RF output about 1 dB.


在 2019年10月16日,上午5:30,Dr. Pedro E. Colla (LU7DID) <lu7did@...> 写道:

No Conor I did not yet.
I had only applied the input level mod but I decided later it wasn’t wise to start adding mods to a circuit
I am not familiar with and then completed the building as vanilla as possible.
73 Pedro LU7DID

El El mar, 15 oct. 2019 a la(s) 18:25, Conor Farrell <conchobhair.ofearghail@...> escribió:
Did you add the optional modification diode to suppress spurious transmissions? If so, this will likely account for the output power drop.


On Tue, 15 Oct 2019, 22:07 Dr. Pedro E. Colla (LU7DID), <lu7did@...> wrote:
Although the power meter shows about 200-300 mW output the current is 22 mA on RX and 290 mA on TX, at 12Vcc this is 3.5W of power input, not sure what is the expected yield of the PA but even taking as low as 50% it should be a good over 1.5W of output. SWR is 1:1.2. The current is aligned with other posts I saw and being regarded as normal for 20 mts. So I can not square the meassured output power with this.

I'm doing some FB contacts at the regional level on 20 mts which isn't bad, this is not a surprise, my beacon is using 100 mW and still being reported all over the world, FT8 is an amazing mode.

73 de Pedro, LU7DID

Join to automatically receive all group messages.